Ariens 911410-WAW 34 Specifications download pdf (Page 21)

PTO Belt

1. Stop engine, remove key, wait for all

moving parts to stop and hot parts to

cool.

2. Remove the two drive belts from engine

pulley. See Wheel Drive Belts on

page 20.

3. Remove the belt cover from the deck.

4. Disconnect the two idler springs from the

spring anchors.

NOTE: Do not remove the bolt holding the

engine pulley to the crankshaft. Loosen it

enough so the PTO belt clears the belt finger.

5. Loosen the bolt holding the engine

pulley to the crankshaft and slide the

pulley down until the PTO belt can be

removed from the pulley.

6. Install the new belt on the engine pulley

and on the deck pulleys.

7. Push the engine pulley up the crankshaft

and tighten the mounting bolt to 55 Ibf-ft

(74.5 a,m).

8. Connect the two idler springs to spring

anchors.

9. Replace the belt cover.

10. Replace the wheel two drive belts on the

engine pulley.

Rear of Unit

2

1. PTO Belt

2. Engine Pulley

3. Idler Arm

6

3

4

4. Tension

Spring

5. Spring Anchor

6. Deck Belt

Figure 16

Deck Belt

1. Stop engine, remove key, wait for all

moving parts to stop and hot parts to

cool.

2. Remove the two drive belts from engine

pulley. See Wheel Drive Belts on

page 20.

3. Remove the PTO belt from the PTO

clutch. See PTO Belt on page 21.

4. Remove the two idler arms from the

deck.

5. Remove the deck belt and install the

new belt.

6. Replace the two idler arms on the deck.

7. Replace the PTO belt on the PTO clutch.

REPLACING MOWER BLADE

Remove (Figure 17)

CAUTION: Mower blades are

sharp and can cut you. Wrap the

blades or wear gloves, and use

extra caution when servicing

them.

1. Block mower blades to prevent rotation.

2. Remove mounting hardware and mower

blades from mower deck.

Install (Figure 17)

1. Install mower blades on spindles with

mounting hardware.

2. Torque 5/8-inch nut to 92 to 130 Ibf-ft

(125 to 176 N°m).

1. Spindle 3. Washer

2. Blade 4. 5/8 in. Nut

Figure 17

GB - 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

Comments to this Manuals

No comments