Ariens 911410-WAW 34 Specifications download pdf (Page 23)

4.Connectpositive(+)cablefirst,then

negative(-)cable.

5.Applypetroleumjellyordielectricgrease

tobatterycableendsandterminals.

6.Replacebeltcover.

Charging the Battery

A

WARNING: FROZEN

BATTERIES CAN EXPLODE

and result in death or serious

injury. DO NOT charge a frozen

battery. Let the battery thaw

before charging.

Follow First Aid directions for contact with

battery fluid.

External Contact: Flush with water.

Eyes: Flush with water for at least 15

minutes and get medical attention

immediately!

Internal Contact: Drink large quantities

of water. Follow with Milk of Magnesia,

beaten egg or vegetable oil. Get

medical attention immediately!

In case of internal contact, DO NOT

induce vomiting!

IMPORTANT: DO NOT fast charge. Charging

at a higher rate will damage or destroy

battery.

IMPORTANT: ALWAYS follow information

provided on battery and battery charger.

Contact battery and battery charger

manufacturers' for detailed instructions.

1. Remove battery from unit (see Battery

Removal and Installation on page 22).

2. Place battery in a well-ventilated area.

3. Connect positive (+) lead of charger to

positive (+) _rminal, and negative (-)

lead of charger to negative (-) terminal.

4. Charge battery according to battery

charger and battery manufacturers'

instructions.

5. Install battery on unit (see Battery

Removal and Installation on page 22).

Jump-Starting

Ariens does not recommend jump-starting

your unit. Jump-starting can damage engine

and electrical system components. See your

engine manual for more detailed information.

CAUTION: AVOID INJURY. Read

_i_ and understand the entire Safety

section before proceeding.

IMPORTANT: NEVER spray unit with high-

pressure water or store unit outdoors. Store

mower in a cool, dry, protected location.

Cleaning

NOTE: Allow unit to cool before cleaning.

Clean unit thoroughly with mild soap and low

pressure water. Brush off dirt and debris from

all surfaces. Touch up all scratched surfaces

to prevent rust. Matching touch-up paint is

available from your Ariens Dealer. Do not use

abrasives, solvents, or harsh cleaners.

Inspection

Inspect mower and repair or replace worn or

damaged parts to avoid delays when

beginning use again.

Regularly check all hardware and keep

fasteners tight. Know unit is in safe working

condition.

Grass Bag

Wash out grass bag and allow to dry before

storage. Grass bag may be stored in position

on mower.

Engine

When storing unit for extended periods of

time, remove all fuel from tank and carburetor

(run dry). Refer to engine manual.

Fuel System

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer according to

manufacturer's instructions.

2. Run engine for at least 10 minutes after

adding stabilizer to allow it to reach the

carburetor.

NEVER store the engine with fuel in the fuel

tank inside of a building with potential

sources of ignition.

GB - 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 61 62

Comments to this Manuals

No comments