Ariens 911410-WAW 34 Specifications download pdf (Page 15)

IMPORTANT:Excessivelyoxygenatedor

reformulatedfuels(fuelsblendedwith

alcoholsorethers)candamagethefuel

systemorcauseperformanceproblems.If

anyundesirableoperatingproblemsoccur,

useagasolinewithalowerpercentageof

alcoholorether.

Fuel Stabilizer

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

EMERGENCY STOPPING

NOTE: The engine will run after the clutch

and parking brake levers are released.

ALWAYS shut off the engine with the ignition

key and remove the key before leaving the

operator's position.

To stop the mower in an emergency:

1. Release the PTO clutch lever and the

parking brake lever.

2. Turn the ignition key to the "OFF"

position.

3. Allow all moving parts to stop before

leaving operator's position.

STARTING AND SHUT OFF

WARNING: Improper operation

can lead to injury. Learn what the

controls do and how they work.

Thoroughly read and understand

entire Operator Manual.

See Figure 6 for all Controls and Features.

NOTE: Start engine on a level surface that is

free of debris.

Electric Start

1. Check each item under Before Each

Use in the MAINTENANCE SCHEDULE

on page 16.

2. Place throttle control in the choke

position. Once the engine has started,

place throttle in the high speed detent.

3. Hold down the safety switch on the dash

panel and turn the ignition key to the

Start position.

4. Release the key and the safety switch

once engine starts.

Shut Off

1. Release the PTO clutch lever, the

parking brake lever, and the wheel drive

controls and allow unit to stop

completely.

2. Turn the ignition key to the "OFF"

position.

Mowing Tips

Cut grass when it is dry.

Keep mower blades sharp.

Do not set cutting height too low. For tall

grass, mow twice.

Do not mow too fast.

Mow with engine at full throttle. Discharge

clippings into areas already cut.

Vary cutting pattern with each mowing.

NOTE: To prevent dirt and grass from

collecting on mower pan, avoid operating

over bare ground with only patches of grass.

Mulching Tips

For best mulching performance, cut no more

than 1 inch (2.54 cm) of grass per cutting.

GB- 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Comments to this Manuals

No comments