Ariens 991040 - Zoom 2660 HD User Manual download pdf (Page 14)

GB - 14

Hour Meter

Records total number of

hours the engine has

been run.

IMPORTANT: Keep a

record of Hour Meter

readings for

recommended Lubrication

and Maintenance

intervals.

NOTE: For accurate readings be sure Ignition

Switch is OFF when unit is not in operation.

FILLING FUEL TANK

Add fuel to Fuel Tank as needed. See your

Engine Manual for correct type and grade of

fuel.

To add fuel to the fuel tank:

1. Place unit in an open or well-ventilated

open area.

2. Stop the engine and allow it to cool.

3. Clean the fuel cap and the area around

the fuel cap to prevent dirt from entering

the fuel tank. Remove the cap from the

fuel tank.

4. Fill the fuel tank to within 1 in. (25 mm)

below bottom of filler neck.

5. Replace fuel cap and tighten.

6. Clean up any spilled fuel.

PRE-START

1. Check Safety Interlock System

If this system does not function as described

do not operate until repairs are made.

2. Check Air Cleaner

Check air filter for dirt. Clean as required.

Follow Engine Manual Maintenance

Schedule.

3. Check Engine Fuel and Crankcase

Oil

Check and add fuel if required. Check that

engine crankcase oil is full. Follow Engine

Manual Maintenance Schedule.

4. Check Tire Pressure

5. Check Hydraulic Fluid Level

6. Adjust Seat

Be sure all controls can be reached safely

from operator’s position.

7. Set Cutting Height

Make sure the deck is set to the correct

cutting height.

STOPPING IN AN EMERGENCY

The unit can be stopped immediately at any

time by turning the ignition key to the "Off"

position.

STARTING AND SHUT OFF

To start the engine:

1. Make sure the steering levers are in

neutral.

2. Put the PTO switch in the “Off” position.

3. Engage parking brake.

4. If the engine is cold, move the choke

control to the “On” position. If the engine

is warm or hot, do not use choke.

5. Move the throttle to 3/4 “Fast” position.

See Engine Manual for detailed

instructions.

6. Put the ignition key in the switch and

turn it to the “Start” position.

7. As soon as the engine starts, release the

key.

8. Move the choke control to the “Off”

position from the “Choke” position. Wait

until the engine is running smoothly

before operation.

To stop the engine:

1. Bring the steering levers to neutral.

Disengage the PTO and engage the

parking brake.

2. Move the throttle lever to the “Slow”

position.

3. Turn the ignition key to the “Off” position.

TO MOW WITH UNIT

Operate the unit only when seated in the

operator’s position.

1. Start the engine. Let the engine warm

until it is running smoothly.

2. Release parking brake.

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

CAUTION: Make sure all

hardware is tight, all safety

devices are in place and all

adjustments are made correctly.

CAUTION: Read entire

Owner/Operator Manual, Clutch

Manual, and Engine Manual first.

DO NOT attempt to start engine

at this time.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Comments to this Manuals

No comments