Ariens 991040 - Zoom 2660 HD User Manual download pdf (Page 9)

GB - 9

NEVER attempt to make any adjustments to

unit while engine is running (except where

specifically recommended). Stop engine,

remove key or spark plug wire and wait for all

moving parts to stop before servicing or

cleaning.

Check parking brake operation frequently.

Adjust and service as required.

ALWAYS maintain unit in safe operating

condition. Damaged or worn out muffler can

cause fire or explosion.

Maintain or replace safety and instruction

labels, as necessary.

NEVER store unit with fuel in fuel tank, inside

a building where any ignition sources are

present.

Shut off fuel and allow engine to cool

completely before storing in closed area or

covering unit.

Clean grass and debris from unit, especially

from around muffler and engine, to help

prevent fires.

For extended storage, shut off fuel and clean

unit thoroughly. See engine manual for proper

storage.

Lower cutting deck unless a positive

mechanical lock is used.

Use only attachments or accessories

designed for your unit.

Check all hardware at regular intervals,

especially blade attachment bolts. Keep all

hardware properly tightened.

Check attachment components frequently. If

worn or damaged, replace with

manufacturer’s recommended parts.

UNIT ASSEMBLY

Package Contents:

Unit, Mower Deck and Literature Pack

Preparation Checklist

Refer to the Owner/Operator manual as

required.

1. Unpack Unit - Remove shrink wrap and

packaging materials.

2. Remove Unit From Container - Open

Bypass Valves (dump valves) (See

Moving the Unit with the Engine Off on

page 15).

Push unit from container onto a level

surface. Close the bypass valves.

3. Tires - See Specifications on page 30.

4. Seat - See Seat Adjustments on

page 13 and Service Position on

page 17.

5. Position Steering Levers - Rotate

eccentric spacers to align handlebars.

Tighten hardware securely. See Aligning

the Steering Levers (Figure 14) on

page 23.

6. Battery - Remove battery from unit and

charge (See Battery on page 21).

ASSEMBLY

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

• Do not attempt to mount a

tire without the proper

equipment and experience

to perform the job.

• Do not inflate the tires

above the recommended

pressure.

• Do not weld or heat a wheel

and tire assembly. Heat can

cause an increase in air

pressure resulting in an

explosion. Welding can

structurally weaken or

deform the wheel.

• Do not stand in front or over

the tire assembly when

inflating. Use a clip-on

chuck and extension hose

long enough to allow you to

stand to one side.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comments to this Manuals

No comments