Ariens 929001 User Manual download pdf (Page 10)

If the reservoir is less than Vt full at ambient temperature,

add TYPE “A" transmission FLUID until proper level is

obtained.

IMPORTANT: ALWAYS USE NEW. CLEAN, TYPE "A"

TRANSMISSION OIL AND BE EXTREMELY CAREFUL

NOT TO ALLOW ANY FOREIGN MATTER TO CON

TAMINATE THE OIL AS SERIOUS TRANSMISSION DAM

AGE COULD RESULT.

00 NOT OVERFILL the reservoir as the oil expands during

operation and may leak out around the cap.

IMPORTANT: PROPER OIL LEVEL IS ESSENTIAL FOR

FULL BRAKING EFFECT AND PROTECTION AGAINST

SEVERE TRANSMISSION DAMAGE. '

STEERING GEARS

Apply a light coat of Ariens Moly Lithium grease to the

steering gears every 50 hours of operation. See Figure 12.

INTERMEDIATE STEERING SHAFT

Apply oil to the bearing surfaces of the blocks every 50

hours of operation. See Figure 16.

pictures. Figures 17 & 18. Each fitting should be wiped

before and after lubrication. Grease each fitting evei

hours of operation with Ariens Moly Lithium grease.

1. Figure 17 — Right and left king pin.

2. Figure 17 — Right and left front wheel.

3. Figure 18 — Hydrostatic control arm pivot

(hydrostatic models)

POINTS TO OIL

Periodically oil the lift point pivots, front axle pivot,

troi linkage pivots and the floating intermediate shaft pi

to insure long life and smooth operation of the parts.

There is no lubrication required on the mower.

IMPORTANT: KEEP GREASE AND OIL OFF THE BE\

TO PREVENT BELT SLIPPAGE AND DETERIORA F/OI

GREASE FITTINGS

Figure 16

Following is a list of the grease fittings with reference

numbers that identify each location on the corresponding

Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 42 43

No comments

Ariens 929001 User Manual Page 10