Ariens 929001 User Manual download pdf (Page 5)

BRAKE LOCK - Figures 2 and 3

A brake lock is provided on both hydrostatic and

gear shift models to prevent the tractor from moving

when parked or left unattended.

^ To lock the brake, push the brake lock forward with the

foot pedal fully depressed. Then release the foot pedal.

Figure 2 shows the brake lock engaged. Figure 3 shows it

disengaged.

IMPORTANT: ENGAGE THE BRAKE LOCK BEFORE DIS

MOUNTING FROM THE TRACTOR OR ANY TIME IT IS

LEFT UNATTENDED.

FREE-WHEELING VALVE (Hydrostatic Models) -

Figure 5

The free-wheeling valve is provided so the tractor

can be pushed short distances with the engine stopped.

The cam arm, see Figure 5, must be in the forward po

sition as shown at all times except when it becomes neces

sary to push the tractor.

CAM ARM IN OPER

ATING POSITION

If it becomes necessary to move the tractor with the engine

stopped, rotate the cam arm rearward so the valve actuating

rod is pushed down into the transmission body. After moving

the tractor the cam arm must be returned to the operating

position before the tractor will move with the engine running.

IMPORTANT: DO NOT TOW TRACTOR AS INTERNAL

TRANSMISSION DAMAGE COULD RESUL T.

Figure 6

IGNITION AND STARTER SWITCH - Figure 6

The ignition and starter switch has three positions;

"off", "run"and "start". Start the engine by turning

the key fully clockwise to start position and then release the

key as soon as the engine starts. Stop the engine by turning

the key counterclockwise to the "off" position.

THROTTLE-CHOKE CONTROL LEVER - Figure 6

This control operates both the throttle and choke.

When starting a cold engine, raise the lever past the

offset and into the "choke" position. After the engine has

started, lower the lever to the throttle operating range and

allow the engine to warm at V4 throttle. Select the appropriate

engine speed in the throttle range after the engine has warmed.

NOTE: Unless otherwise specified, the mower or snow thrower

should be operated at full throttle. The throttle is not to be

used to select desired travel speeds with the hydrostatic

models. Operate at full throttle and regulate ground speed

with the hydrostatic control lever.

LIGHT SWITCH (Optional)-(Figure 6)

If the optional light kit is installed, turn lights on by

pulling the control knob out. Turn lights off by

pushing the knob in;

ATTACHMENT LIFT LEVER-(Figure 7)

The lift lever shown in figure 7 is used to raise and

lower the mower, front blade or snow thrower.

To raise the attachment, pull the lever to the rear until

the latch snaps into the notch provided. This will hold the

attachment in the raised position.

Figure 5

Page 5

1 2 3 4 5 6 7 8 9 10 ... 42 43

Comments to this Manuals

No comments

Ariens 929001 User Manual Page 5

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 929001