Ariens 22-Ton Log Splitter Specifications download pdf (Page 12)

GB - 12

Out/Down (1) – Move lever in this direction to

extend cylinder toward end plate. Keep

pressure on lever until log is split. Lever does

not lock in this position. Release as soon as

log is split or cylinder is fully extended.

NOTE: Splitter wedge is designed to reach

full extension and stop between 1 and 2" (25

and 50 mm) before contacting end plate.

IMPORTANT: When cylinder is fully

extended do not hold lever in out position.

Pump damage will result.

Neutral (2) – In this position the cylinder does

not move even though the engine is running.

Return/Up (3) – Move lever in this direction to

retract cylinder. Push lever fully in this

direction to lock in return mode. Lever will

automatically return to neutral once cylinder

fully retracts.

Beam Lock

Locks the beam in the horizontal operating

position. To move beam to vertical operating

position:

1. Pull beam lock out until the pin clears

the mount (Figure 10).

2. Rotate beam lock slightly so pin does

not return to hole in mount.

3. Lift beam until it rotates to vertical

position (Figure 11).

IMPORTANT: Rear stabilizer must be in the

transport position before placing beam in

vertical operating position (see Rear

Stabilizer on page 14).

To move beam to horizontal position:

1. Carefully rotate beam down until seated

on lock bracket.

2. Turn beam lock until pin lines up with

hole in lock bracket and release

(Figure 10).

3. Ensure that beam lock pin fully engages

in bracket.

Stripper Plates

(Figure 12)

The stripper plates are designed to remove a

log that has partially split but remains stuck

on the wedge.

To remove stuck logs from the splitter wedge:

1. Move the control lever to the Return/Up

position.

2. Allow the cylinder to retract until the

stuck log contacts the stripper plates.

WARNING: Keep hands and

fingers away from splitter wedge

and stripper plates during cylinder

retraction.

CAUTION: Beam assembly is

heavy. Use care when moving

between vertical and horizontal

positions.

Figure 10

Beam

Lock

Figure 11

Figure 12

Stripper Plates

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments