Ariens SNO-THRO 924333 - 1024 User Manual download pdf (Page 11)

GB - 11

Check Function of all Controls

Ensure unit runs and performs properly. Refer to

Operation

STANDARD CONTROLS

See Figure on page 3 for all Controls and Features

locations.

Dual Handle Interlock

When Attachment Clutch and then Traction Drive

Clutch are engaged, the Attachment Clutch will remain

engaged (lever down) if released. To stop attachment,

release Traction Drive Clutch and both clutches will

disengage.

Traction Drive Clutch - Left Hand Lever

Squeeze the Traction Drive Clutch

Lever against the Handlebar (1) to

engage wheel drive for propelling

unit. Forward speed will vary

according to snow depth and

moisture content.

Release lever to stop movement (2).

NOTE: When traveling to or from the area to be

cleared, press down on the handlebars enough to raise

the front of the unit slightly off the surface. Engage the

traction drive clutch without engaging the auger drive

clutch.

Attachment Clutch - Right Hand Lever

Squeeze Attachment Clutch Lever

against Handlebar (1) to engage

attachment. Release both clutch

levers (2) to disengage power and

apply brake to attachment.

IMPORTANT: If the belt squeals

when the attachment clutch lever is

engaged, the attachment drive may

be frozen. Immediately release the

attachment clutch lever and move the unit into a heated

area to thaw.

Ignition Key (120V start on engine)

Key Switch has two positions:

1. “Stop”

2. “Run”

NOTE: DO NOT twist key after it is

inserted.

Ignition Key (12V start on dash panel)

The ignition switch is operated by a

removable key. It has three positions:

1.“Stop”

2.“Run”

3.“Start”

Primer Bulb

Pushing the Primer Bulb in adds fuel for

easier engine start (see Starting and Shut

Off).

Speed Selector

The Speed Selector controls the unit travel in a forward

or reverse direction when positioned in notch of speed.

Forward:

(6) “Fastest”

(1) “Slow” (Best used for removing deep

or hard packed snow)

Reverse:

(1) “Slow”

(2) “Fast”

IMPORTANT: DO NOT change motion

from forward to reverse with clutch

engaged. Forward speed can be

changed without declutching.

Choke Control Knob

1. Choke Closed position: chokes off

air to engine for easier start.

2. Choke Open position: allows for

normal operation.

IMPORTANT: Gradually open choke

after engine starts.

Throttle

The Throttle controls the engine speed. To

increase or decrease the engine speed,

adjust to:

1.“Fast” (normal or warm starts)

2.“Part-Throttle”

3.“Slow” (cold weather starts)

4.“Stop” (engine is off)

OPERATION

WARNING: AVOID INJURY. Read and

understand Operational, Fuel and Battery

Safety Rules before proceeding.

OL2701

OL2691

OS1431

OS0232

OS1321

OS1190

OS1300

STOP

OL2720

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Comments to this Manuals

No comments

Ariens SNO-THRO 924333 - 1024 User Manual Page 11

Comments to this Manuals

Related products and manuals for Cars Ariens SNO-THRO 924333 - 1024