Ariens SNO-THRO 924333 - 1024 User Manual download pdf (Page 14)

GB - 14

IMPORTANT: DO NOT operate starter more than 15

seconds per minute, as overheating and damage can

occur. (If engine does not start, refer to

Troubleshooting.)

9. Adjust choke as needed.

10. Disconnect power cord from receptacle.

11. Set throttle to “Part Throttle” or “Slow” position for

adaptation to Ambient temperature or transport.

Once achieved, set throttle to “Fast” position for

normal operation.

Electric Start (12V)

1. Turn discharge chute straight ahead.

2. Make sure that the traction clutch and attachment

drive clutch levers are fully disengaged.

3. Push Primer Bulb 2 or 3 times for cold engine.

NOTE: When temperature is below -15˚ F (-26˚ C)

additional priming may be needed.

4. If engine is cold, apply choke. See Engine

Manual for detailed instructions.

NOTE: A warm engine requires less choking than a

cold engine.

5. Set throttle to proper starting position.

6. Put ignition key into START position until engine

starts and release into the RUN position.

IMPORTANT: DO NOT operate starter more than 15

seconds per minute, as overheating and damage can

occur. (If engine does not start, refer to

Troubleshooting.)

7. Adjust choke as needed.

8. Set throttle to “Part Throttle” or “Slow” position for

adaptation to Ambient temperature or transport.

Once achieved, set throttle to “Fast” position for

normal operation.

Normal Shut Off

1. Release Traction Drive Clutch Lever and allow

unit to come to a complete stop.

2. Run Impeller a few minutes after use to prevent

freeze-up of Impeller.

3. Release Attachment Clutch Lever and wait for all

moving parts to come to a complete stop.

4. Move Throttle to the “Slow” Position.

5. Move key into “Stop” position.

6. Remove key.

THROWING SNOW

IMPORTANT: Allow unit and engine to adjust to the

outdoor temperatures before clearing snow.

NOTE: Attachment clutch should be engaged before

wheel drive clutch when throwing snow.

1. Select Speed Control position and direction.

2. Engage Attachment Clutch - Right Hand Lever.

3. Engage Traction Drive Clutch - Left Hand Lever.

IMPORTANT: DO NOT overload unit capacity by

attempting to clear snow at too fast a rate.

Tips for Operation

Snow is best removed as soon as possible after snow

fall.

To clear an area, run unit in an overlapping series of

paths. For large areas; start in the middle and throw

snow to each side, so snow is not cleared more than

once.

ALWAYS direct snow away from area to be cleared and

with direction of the wind.

TRAVELING

To travel from one work area to another:

1. Set Throttle to "Slow" or "Part-Throttle" position.

2. Press down on handlebars enough to raise front

of unit slightly off surface.

3. Engage wheel drive clutch without engaging

attachment drive clutch.

TRANSPORT

ALWAYS shut off engine, remove key and drain fuel

when transporting unit on a truck or trailer.

Use extra care when loading or unloading unit onto

trailer or truck.

Secure unit chassis to transport vehicle. NEVER

secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

Comments to this Manuals

No comments

Ariens SNO-THRO 924333 - 1024 User Manual Page 14

Comments to this Manuals

Related products and manuals for Cars Ariens SNO-THRO 924333 - 1024