Ariens SNO-THRO 924333 - 1024 User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 25
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
GB - 19
10. Place belt onto engine sheave.
11. Make sure engine and attachment sheaves align.
If alignment is necessary, loosen attachment
sheave set screws, reposition sheave and
retighten set screws.
12. Reposition and secure belt ngers.
IMPORTANT: Make sure belt ngers are 1/16" to 1/8"
(2-3mm) from belt when attachment clutch is engaged.
13. Check adjustment. See Attachment Clutch/Brake.
14. Reconnect chute crank and secure with spring
clip. If equipped, reconnect remote cap deector
cable and/or electric chute wire harness.
15. Replace belt guard cover.
TRACTION DRIVE BELT
NOTE: Housing and frame must be tipped apart and
attachment drive belt removed from engine sheave in
order to change traction drive belt.
1. Follow steps 1 through 7 under Attachment Drive
Belt.
2. Pull idler away from belt and remove belt from
idler pulley, engine and driven pulley (it may be
necessary to turn engine pulley using recoil
handle).
NOTE: To gain clearance engage traction clutch and if
necessary pull back attachment idler arm clevis pin.
3. Install new traction drive belt onto attachment and
engine sheaves.
4. Follow steps 8-15 under Attachment Drive Belt.
SHEAR BOLTS
IMPORTANT: Use only Ariens Shear Bolts for
replacement. Use of any other type of shear bolt may
result in severe damage to unit.
Occasionally a foreign object may enter the
auger/impeller housing and jam the auger, breaking
Shear Bolts (Figure 16) which secure the auger to the
shaft. This allows auger to turn freely on the shaft
preventing damage to gear drive.
For Replacement:
1. Slide auger outward against roll pin and align
hole in shaft with hole in auger (holes in shaft for
roll pins and Shear Bolts line up).
2. Drive shear bolt through hole (if shear bolt was
broken this will drive remaining part from shaft).
WARNING: AUGER / IMPELLER MUST
STOP within 5 seconds when Attachment
Clutch Lever is released or unit damage or
serious injury may result.
1. Traction Belt Idler
2. Cap Screw
3. Belt Finger
4. Attachment Belt Idler
5. Traction Drive Belt
6. Attachment Drive
Belt
7. Attachment Idler
Adjustment
Hardware
1
2
3
4
5
6
7
Figure 14
OS0601
8. Pivot Pin
9. Housing Cap Screws
10. Belt Guard Cover
3
1
2
Figure 15
OS0792
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments