Ariens 991800-ProZoom 2352S Specifications download pdf (Page 7)

GB - 7

Periodically check the starting circuit to make sure all system

components operate correctly.

If the starting system does not work, consult your Ariens

Dealer immediately.

Operate the mower only in daylight or when the area to be

mowed is lit well by artificial light.

Never remove the discharge shield from the mower because

the discharge shield directs material down toward the turf. If

the shield is damaged, be sure to replace it immediately.

Never try to clear the discharge area or the mower blades

unless you have moved the steering control levers to the

park position, put the PTO switch in the "Off" position,

switched the ignition key to the "Off" position, removed the

ignition key and disconnected the negative battery cable.

Do not operate the power unit in a confined or non-ventilated

area. Carbon monoxide gas is colorless, odorless, and can

be fatal.

Do not turn sharply when driving at high speeds.

Park the mower on a firm level surface with the steering

control levers in the park position.

When backing, be sure to turn around and look to the rear.

Do not mow in reverse unless it is absolutely necessary.

When working in groups, use caution and watch out for

others.

Always be aware of mower discharge direction. Make sure it

does not point at anyone.

Be sure the engine and rotating blades have stopped before

putting hands or feet near the blade.

Disengage the blade drive when transporting the machine

across drives, sidewalks, etc. Never raise the mower deck

while the blades are turning.

Do not put hands or feet under or into the mower when it is

running.

Do not touch the engine or muffler when the engine is

running or immediately after the engine has stopped. These

areas may be hot enough to cause serious burns.

Do not drive the machine on streets or highways. Watch for

traffic when crossing streets or while mowing close to roads.

Always inspect the mower for damage after striking a foreign

object. Always repair or replace damaged parts before

restarting the mower deck.

Do not operate the power unit without the mower deck

attached.

Make sure the machine and all attachments come to a

complete stop before dismounting.

Before dismounting, disengage the PTO, lower all

attachments, place the steering control levers in the park

position, turn off the engine, and remove the key.

Operating On Slopes

Avoid starting or stopping when going up or down a slope.

Keep all movements on a slope gradual and slow. Do not

make sudden changes in speed or direction.

If tires lose traction while on a slope, disengage the mower

blades and back slowly and gradually down the slope.

Do not turn on slopes unless necessary, and then turn slowly

and gradually downhill if possible.

Use extra caution when mowing on slopes. If you are unable

to back up on the slope, or if you do not feel comfortable on

it, then do not mow it. Do not operate the machine on slopes

that exceed 15°.

Mow across slopes, not up and down, to avoid machine

tip-over. Do not mow slopes or hills that are too steep for

safe operation.

Do not try to stabilize the machine by putting your foot on the

ground.

ROLL OVER PROTECTIVE STRUCTURE (ROPS)

Do not weld, drill or alter the ROPS. Damaged ROPS must

not be straightened or used. If damage does occur, consult

your Dealer and replace all damaged parts.

If the ROPS is lowered or removed from the power unit for

any reason, it must be erected and/or refitted immediately.

Original bolts or equivalent replacements must be used and

tightened to the correct torque.

Do not attach chain, ropes, or cables to the ROPS for pulling

purposes as this will cause the mower to tip backwards.

Ariens does not recommend the use of the mower with the

ROPS removed.

If you have a foldable ROPS, it can be folded down for

mower storage. It must be pinned in the upright position prior

to machine operation.

SEAT BELT USAGE

With the ROPS installed, it is imperative that the seat belt be

installed, used, and correctly adjusted at all times. Replace

damaged seat belts immediately.

Do not use a seat belt if operating with ROPS folded down or

removed.

MAINTENANCE

Only qualified, trained adults should service the machine.

Before maintenance is performed, make sure the mower is

parked on a firm flat surface. Remove the key to prevent an

accidental start up.

Never attempt to disconnect any safety devices.

Frequently check for worn or deteriorating components that

could create a hazard.

Use only genuine Ariens replacement parts. Substitute parts

could cause product malfunction or possible injury to the

operator or bystanders.

If it is necessary to have the engine running while making

maintenance adjustments, keep hands, feet, and clothing

away from all moving parts.

When making adjustments while the engine is running such

as carburetor and motion control linkage adjustments, stand

to either side of the tractor and mower and keep clear of

moving or rotating components.

Allow the Ariens mower time to cool before touching the

engine, muffler, or any other part which may be hot.

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 7

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S