Ariens 991800-ProZoom 2352S Specifications download pdf (Page 30)

GB - 30

SHORT TERM

NEVER spray unit with high-pressure water or store unit

outdoors.

Inspect unit for visible signs of wear, breakage or damage.

Keep all nuts, bolts and screws properly tightened and know

unit is in safe working condition.

Store unit in a cool, dry protected area.

LONG TERM

Clean unit thoroughly with mild soap and low-pressure water

and lubricate (see Maintenance Schedule on page 17).

Touch up all scratched painted surfaces.

Remove weight from wheels by putting blocks under frame

or axle.

Clean and charge the battery. Charge battery every three to

four weeks when storing unit.

Fuel System

Gasoline left in the fuel system for extended periods without

a stabilizer will deteriorate, resulting in gum deposits in the

system. These deposits can damage the carburetor and the

fuel hoses, filter and tank. Prevent deposits from forming in

the fuel system during storage by adding a quality fuel

stabilizer to the fuel. Follow the recommended mix ratio

found on the fuel stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer according to manufacturers’

instructions.

2. Run engine for at least 10 minutes after adding

stabilizer to allow it to reach the carburetor.

NEVER store the engine with fuel in the fuel tank inside of a

building with potential sources of ignition.

TO TAKE THE UNIT OUT OF STORAGE

1. Refer to the engine service manual to prepare the

engine for service.

2. Put fresh, clean fuel in the fuel tank.

3. Begin the maintenance schedule.

4. Charge the battery.

STORAGE

WARNING: AVOID INJURY. Read and

understand entire Safety section before

proceeding.

TROUBLESHOOTING

PROBLEM PROBABLE CAUSE CORRECTION

Excessive Vibration 1. Loose spindle/blade fasteners.

2. Blade interference with grass buildup in

deck.

3. Blades out of balance.

4. Blade(s) broken or worn badly.

5. Engine mounting bolts are loose.

6. Engine/Idler/Blade pulley loose.

7. Engine pulley damaged.

8. Failed spindle bearing.

1. Retorque or replace as necessary.

2. Clean the underside of the deck.

3. Balance blades. See Blade Maintenance

on page 27.

4. Replace blades in set of three.

5. Tighten the engine mounting bolts.

6. Tighten the pulley.

7. Contact Dealer.

8. Contact Dealer.

Uneven Cutting Height 1. Blades dull.

2. Cutting blades bent.

3. Deck not level.

4. Anti-scalp not set correctly.

5. Grass buildup under deck.

6. Incorrect tire pressure.

7. Blade spindle bent.

8. Ground speed too fast.

1. Sharpen or replace blades.

2. Install new blades.

3. Level deck.

4. Adjust height of anti-scalp wheel.

5. Clean underside of deck.

6. Adjust psi to 12 psi rear and 20 psi front.

7. Contact Dealer.

8. Lower ground speed.

Blades Wear Too Fast 1. Cutting in sandy conditions.

2. Cutting in rocky conditions.

3. Heat treat has been removed by

sharpening with grinder.

1. Increase deck mowing height.

2. Increase deck mowing height.

3. Replace blades in sets of three.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 30

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S