Ariens 991800-ProZoom 2352S Specifications download pdf (Page 24)

GB - 24

LEVELING THE DECK

1. Set the front tire pressure to 20 p.s.i. and the rear tire

pressure to 12 p.s.i.

2. Place the mower on a level surface.

3. Raise the mower deck to the transport lock position

and adjust the cut height to 3 inches.

4. Lower the deck back to cut position.

5. Set both of the outside blades to be perpendicular to

the mower as shown in figure 18.

6. Measure the height of the blade tips on both 1 and 2

and adjust the front adjustment bolts and the rear

U-bolts to ensure the deck is level from left to right.

7. Rotate the mower blades 90° so they are parallel to the

mower deck. Use the rear adjustment bolts to adjust

the deck so that the rear blade tip is 1/8” higher than

the front blade tip on the same blade.

Measure the blade heights to make sure they match what is

shown on the height of cut dial. The height is measured as

the distance between the ground and the bottom of the

blade. If the blade height does not match the dial height, see

Synchronizing Height Of Cut (Figure 20) below.

Synchronizing Height Of Cut (Figure 20)

NOTE: Make sure the deck is level before synchronizing the

height of cut dial with the deck blade height.

1. Raise the mower deck to the transport position. Take

the weight off of the deck lift linkage (1) by inserting

wood blocks under each corner of the deck and slowly

lowering it until it is resting on the blocks.

2. Loosen the 1/2 jam nut (3) from the 1/2" adjustable

yoke (2).

3. Pull the 1/2” clevis spring pin (5) out of the adjustable

yoke and disconnect the yoke from the lift linkage (1).

If the blade height is higher than the height of cut dial,

tighten the yoke onto the 1/2-13 x 4.5” bolt (6) which

runs through the height of cut index arm weldment (4).

If the blade height is lower than the height of cut dial,

then loosen the yoke on the 1/2-13 x 4.5” bolt (6).

NOTE: Set the height of cut on the front tip of the center

blade.

4. Connect the 1/2" adjustable yoke (2) to the lift linkage

(1) with the 1/2” clevis spring pin (5).

5. Tighten the 1/2" jam nut (3) back down to lock the

setting into position.

6. Raise the deck back to the transport height and

remove the blocks from below the deck. Measure the

blade height again to ensure it now matches the height

on the dial. If not, repeat until the two heights are

synchronized.

CAUTION: Stop the engine, put the steering

control levers in the park position and remove

the key from the ignition before performing any

maintenance or repairs on this unit.

Figure 18

OM5045

Figure 19

OE3305

CAUTION: Stop the engine, put the steering

control levers in the park position and remove

the key from the ignition before performing any

maintenance or repairs on this unit.

Figure 20

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 24

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S