Ariens 991800-ProZoom 2352S Specifications download pdf (Page 20)

GB - 20

Engine Oil Change

Change the engine oil and filter after the first 8 hours of

operation. Change the oil each subsequent 100 hours of

operation after the initial change.

1. Run the engine to warm the oil.

2. Park the mower on level ground.

3. Stop the engine, put the steering control levers in the

park position and remove the key.

4. Remove the oil drain screw, see figure 14, and drain

the oil into a suitable container while the engine is still

warm.

5. Install the oil drain screw.

6. Remove the dipstick and refill with fresh oil.

7. Check the oil level.

HYDRAULIC SYSTEM MAINTENANCE

IMPORTANT: Avoid damage to hydraulic components as a

result of contamination. Be sure to wipe around the filler

neck and cap before removal of the hydraulic oil reservoir

cap. Do not open the oil reservoir cap when hot unless it is

absolutely necessary.

Check the reservoir daily for the proper fluid level.

The pump and motor units require fluid changes yearly or

every 250 hours whichever occurs first. The system filter

should be changed initially after the first 50 hours of

operation. The fluid and filter must be changed and the

system cleaned if the fluid would become contaminated with

dirt, water, etc.

NOTE: The integrated pump/motor units are equipped with

bypass valves. See Moving the Unit with the Engine Off on

page 16.

Changing Hydraulic Fluid

1. Park the machine on a level surface, stop the engine,

put the steering control levers in the park position and

remove the key.

WARNING: Engine oil is a toxic substance.

Dispose of used oil properly. Contact your local

authorities for approved disposal methods or

possible recycling.

WARNING: Hot engine oil can cause severe

burns. Allow engine oil temperature to drop from

hot to warm before attempting to drain and

handle the oil.

Figure 13

Clean

Engine Oil

Figure 14

Oil Drain

Screw

Engine Oil

Filter

OE3290

WARNING: HYDRAULIC FLUID can result in

severe burns. Fluid in hydraulic system can

penetrate skin and result in serious injury or

death.

Be sure to stop the engine before doing any

work on hydraulic parts.

Keep body and hands away from pin holes or

nozzles which expel hydraulic fluid when under

pressure. Use paper or cardboard, not hands,

to search for leaks.

Ensure all hydraulic fluid connections are tight

and all hydraulic hoses and lines are in good

condition before applying pressure to system.

FOREIGN FLUID INJECTED INTO BODY can

result in gangrene. Fluid must be surgically

removed within a few hours by a doctor familiar

with this form of injury.

CAUTION: Be sure the engine has been

stopped, the steering control levers are in the

park position, and the key has been removed

before changing or checking the hydraulic oil in

the mower.

Allow the hydraulic fluid to cool. The oil may be

hot and could cause serious burns.

CAUTION: Be sure the engine has been

stopped, the steering control levers are in the

park position, and the key has been removed

before changing or checking the hydraulic oil in

the mower.

Allow the hydraulic fluid to cool. The oil may be

hot and could cause serious burns.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 20

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S