Ariens SNO-THRO 938016 - 522 Specifications download pdf (Page 11)

GB - 11

STARTING AND SHUTOFF

IMPORTANT: At start up, allow unit and engine to

adjust to the outdoor temperatures before clearing

snow. Before shut off, run auger a few minutes to

prevent freeze-up of auger.

NOTE: Try out each control without the engine running

to see how they work and what they do.

Manual Start

1. Turn discharge chute straight ahead.

2. Push primer Bulb 1 to 3 times for cold engine.

NOTE: When temperature is below -15° F (-26° C)

additional priming may be needed.

3. Pull choke control knob out.

NOTE: A warm engine requires less choking than a

cold engine.

4. Insert key into ignition switch.

5. Turn key to "Run" position.

6. Stand to right of unit. Grasp starter handle and pull

rope out slowly until it pulls harder, this is

compression stroke, let rope rewind slowly.

7. Pull rope with a rapid continuous full arm stroke.

Let rope rewind slowly.

IMPORTANT: DO NOT let starter handle snap against

unit.

8. Repeat until engine starts. (If engine does not

start, refer to Troubleshooting.)

9. When engine has started, open choke slowly by

gradually pushing choke control knob in.

Electric Start (optional)

IMPORTANT: DO NOT crank engine for more that 20

seconds. ALWAYS allow starter to cool down for 10

minutes between each try or starter will be damaged.

1. Turn discharge chute straight ahead.

2. Push primer Bulb 1 to 3 times for cold engine.

NOTE: When temperature is below -15° F (-26° C)

additional priming may be needed.

3. Pull choke control knob out.

NOTE: A warm engine requires less choking than a

cold engine.

4. Insert key into ignition switch.

5. Turn key to "Run" position.

6. Connect Female End of power cord to switch Box.

7. Plug Male End of power cord into 120 Volt AC

receptacle.

8. Push starter button to crank engine.

9. When engine starts, release starter button

10. Open choke slowly by gradually pushing choke

control knob in.

11. Disconnect power cord from receptacle ﬁrst, then

from switch box.

Shutoff

1. Engage and run auger a few minutes after use to

prevent freeze-up of auger.

2. Release auger clutch bail and allow auger to stop.

3. Turn ignition switch to "Stop" position.

4. Remove key.

WARNING: FAILURE TO FOLLOW

INSTRUCTIONS could result in personal

injury and/or damage to unit. DO NOT attempt

to start your unit at this time. Read entire

Owner/Operator Manual and the Engine

Manual ﬁrst.

WARNING: THROWN OBJECTS could cause

death or serious injury. ALWAYS position

discharge chute straight ahead (away from

operator) for starting.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

Ariens SNO-THRO 938016 - 522 Specifications Page 11

Comments to this Manuals

Related products and manuals for Snow throwers Ariens SNO-THRO 938016 - 522