Ariens SNO-THRO 938016 - 522 Specifications download pdf (Page 8)

GB - 8

TOOLS REQUIRED

• 7/16" Open-end wrench

TO REMOVE UNIT FROM CARTON

1. Cut off top of carton.

2. Remove front and rear inserts and literature pack.

3. Cut out back of carton and roll unit out.

4. Remove protective packaging materials.

ASSEMBLY

Handlebar Assembly

1. Remove retaining nuts and handlebar knobs and

release J-bolts from lower handlebar.

2. Unfold upper handlebar.

NOTE:

Adjust handlebar to a height comfortable for the

operator. Refer to

Handlebars

Operation.

3. Put J-bolts through the upper handlebar and lower

handlebar holes.

4. Replace retaining nuts and tighten handlebar

knobs to secure upper handlebar.

Discharge Chute Assembly

1. Remove screw and nut from rear of discharge

chute.

2. Tip discharge chute up and install hardware just

removed. Tighten hardware at rear of discharge

chute ﬁrst, then sides.

CHECKLIST

Please complete the following checklist before

proceeding:

❑

All assembly instructions have been completed.

❑

No remaining loose parts in carton.

❑

Handlebar is adjusted comfortably and tightened

securely.

While learning how to use your unit, pay extra

attention to the following important items:

❑

Fill fuel tank with proper gasoline/oil mix.

❑

Become familiar with all controls – their location

and function.

❑

Be certain that all hardware is properly tight-

ened.

Hardware/

Literature

Pack

OS1510

1. Lower Handle Bar

2. Upper Handle Bar

3. J-Bolt

4. Knob

5. J-Bolt Holes

6. Auger Clutch Bail

7. Retaining Nuts

OS1530

1. Discharge Chute

2. Rear Screw and

Nut

3. Side Hardware

4. Chute Handle

OS1520

ASSEMBLY

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Ariens SNO-THRO 938016 - 522 Specifications Page 8

Comments to this Manuals

Related products and manuals for Snow throwers Ariens SNO-THRO 938016 - 522