Ariens SNO-THRO 938016 - 522 Specifications download pdf (Page 14)

GB - 14

SERVICE POSITION

Place unit on a ﬂat level surface.

TO ADJUST DISCHARGE CHUTE

DEFLECTOR

If discharge chute deﬂector does not stay in set

position during operation, adjust chute by tightening

fasteners evenly until deﬂector stays in position.

NOTE: Use a T30 Torx Drive or a 3/16” (.19 cm) wide

Straight Screwdriver to tighten.

TO REPLACE THE DRIVE BELT

1. Remove fuel cap.

2. Remove cowl and replace fuel cap.

3. Disconnect extension spring on idler arm/brake.

4. Remove cap screw and washer from end of auger

shaft and pull off auger drive pulley.

5. Remove old belt.

6. Install new belt onto pulleys

7. Reinstall auger drive pulley and secure with

washer and cap screw

8. Reconnect extension spring to idler arm/brake.

9. Ensure belt ﬁnger(s) and auger clutch control cable

are properly adjusted. See To Adjust Belt Finger

and To Adjust Auger Control Cable.

10. Remove fuel cap and replace cowl.

11. Replace fuel cap.

TO ADJUST BELT FINGER

3HP units have two belt ﬁngers.

5HP units have one belt ﬁnger.

With the auger clutch engaged, there should be 1/32 to

1/16" (1-1.6 cm) clearance between the belt ﬁnger and

drive belt.

To adjust:

1. Loosen bolt holding the belt ﬁnger.

2. Rotate the belt ﬁnger around the bolt to the correct

position.

3. Tighten bolt.

WARNING: ACCIDENTAL ENGINE START

UP can cause death or serious injury.

ALWAYS stop engine, remove key, and wait

for moving parts to stop before performing

maintenance or service.

HOT SURFACES can cause death or serious

injury. DO NOT touch parts which are hot from

operation. ALWAYS allow parts to cool.

CAUTION: FUEL SPILLS may result in minor

or moderate injury and/or damage to unit. If

unit must be tipped, remove enough fuel so

that no spills will occur.

Fasteners

OS0181

1. Extension Spring

2. Idler Arm/Brake

3. Idler

4. Slot

5. Belt Fingers

6. Auger Clutch

Control Cable

7. Drive Belt

8. Auger Drive Pulley

9. Cap Screw, Washer, Auger Shaft

OS0053

1/32"-1/16"

(1-1.6 cm)

5 (3HP)

SERVICE AND ADJUSTMENTS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ariens SNO-THRO 938016 - 522 Specifications Page 14

Comments to this Manuals

Related products and manuals for Snow throwers Ariens SNO-THRO 938016 - 522