Ariens 917012 Specifications download pdf (Page 13)

EN - 13

IMPORTANT: Rear stabilizer must be in the

transport position before placing beam in

vertical operating position

(see Rear

Stabilizer (Item 12) on page 14).

To move beam to horizontal position:

4. Carefully rotate beam down until seated

on lock bracket.

5. Turn beam lock until pin lines up with

hole in lock bracket and release

(Figure 6).

6. Ensure that beam lock pin fully engages

in bracket.

Stripper Plates (Item 13)

(Figure 8)

The stripper plates are designed to remove a

log that has partially split but remains stuck

on the wedge.

To remove stuck logs from the splitter wedge:

1. Move the control lever to the Return/Up

position.

2. Allow the cylinder to retract until the

stuck log contacts the stripper plates.

3. Continue to retract the cylinder until the

log is dislodged from the splitter wedge.

4. Once removed from the splitter wedge

rotate log and split from a different

location or split log from the other end.

Figure 7

CAUTION: Do not use the unit if

the stripper plates are bent or

damaged. Bent or damaged

stripper plates must be repaired

or replaced before use.

Figure 8

Stripper Plates

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Comments to this Manuals

No comments