Ariens 917012 Specifications download pdf (Page 20)

EN - 20

6. Reinstall hydraulic suction hose and

tighten hose clamp.

7. Lubricate rubber gasket on new oil filter

with clean hydraulic oil.

8. Spin new oil filter onto filter housing until

it makes contact. Tighten oil filter

another 1/2 turn.

9. Add new oil to the oil tank.

10. Check hydraulic oil level.

11. Properly dispose of waste oil.

Purge Air From Hydraulic System

1. With the engine running, extend the

hydraulic cylinder out fully and then

retract fully.

2. Repeat 4 – 5 times. Erratic movement in

the hydraulic cylinder indicates that

there is air in the system.

3. Stop the engine and check the hydraulic

oil level. Add if necessary.

4. Repeat extending and retracting of

hydraulic cylinder unit motion is

consistent and smooth in both

directions.

5. Ensure that hydraulic oil is at proper

level.

IMPORTANT: At this point a large amount of

hydraulic oil has been drawn into the

hydraulic cylinder and hoses. Be sure to refill

the oil reservoir to prevent pump damage.

SHORT TERM

NEVER spray unit with high pressure water

or store unit outdoors.

Inspect unit for visible signs of wear,

breakage or damage.

Keep all nuts, bolts and screws properly

tightened and know unit is in safe working

condition.

Store unit in a cool, dry protected area.

Protect bare-metal areas with a light coat of

oil or anti-rust compound.

LONG TERM

Perform all steps found in Short Term

storage.

Touch up all scratched painted surfaces.

Remove weight from wheels by putting

blocks under frame or axle.

Fuel System

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer (Ariens part number

00592900) according to manufacturer’s

instructions.

2. Run engine for at least 10 minutes after

adding stabilizer to allow it to reach the

carburetor.

NEVER store the engine with fuel in the fuel

tank inside of a building with potential

sources of ignition.

To Take the Unit Out of Storage

1. Refer to the engine service manual to

prepare the engine for service.

2. Put fresh, clean fuel in the fuel tank.

3. Begin the maintenance schedule.

STORAGE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments