Ariens String Trimmer Specifications download pdf (Page 13)

GB - 13

TRANSPORTING UNIT

ALWAYS shut off engine, and close fuel shut-

off valve or drain fuel when transporting unit

on a truck or trailer. Tie unit down securely.

Do not tie down by linkages, guards, cables

or other parts that may be damaged.

FOR BEST PERFORMANCE

Whenever possible keep the wheels on a

hard, flat surface.

Edge thawed ground. Frozen or rocky ground

can damage blade.

Dry, hard surfaces will raise a lot of dust.

When possible edge ground that is moist but

not muddy or saturated.

IMPORTANT: Proper maintenance can

prolong the life of unit. The following chart

shows the recommended service schedule.

Refer to the maintenance instructions in the

Engine Manual for additional information.

MAINTENANCE SCHEDULE

WARNING: AVOID INJURY.

Read and understand the entire

Safety section before

proceeding.

Interval Task Action

Each Use

Check Safety

Interlock System

WARNING: Safety interlock system failure and

improper operation of unit can result in death or

serious injury. Test this system each time the unit

is operated. If this system does not function as

described, do not operate until repairs are made.

See Operator Presence Control on page 9.

Clean Unit Remove all dirt, grease, leaves, etc.

Check Tires Make sure the tires are positioned correctly for the

intended job and are securely fastened. See Rear Wheel

Height Adjuster on page 10 and Front Wheel Adjuster on

page 11.

Check Edger Blade

and Mounting

Hardware

Make sure the blade is free of nicks, broken ends, thinned

metal or other damage. Make sure the hardware is

tightened to 30 – 62 lbf-ft. (40.7 – 84.0 N•m). See Blade

Change on page 14.

Check Guards and

Mounting Hardware

Make sure all guards are securely fastened and are in

good repair.

Check Engine Oil

Level

Check the engine oil level according to instructions

provided in the engine owner’s manual.

Check Engine Air

Filter

Check the engine air filter for dirt and debris according to

instructions provided in the engine owner’s manual. Clean

or replace as needed.

25 Hours

or Every

Season

Lubrication Apply a light oil to the pivot shaft and all sliding joints, to

the front axle shaft and to the wheel bushings.

Change engine oil according to instruction provided in the

engine owner’s manual.

50 Hours

or Every

Season

Check Belt Check the belt for cuts, nicks or abrasions. Replace worn

or damaged belts. See Belt Change on page 14.

Check Spindle

Bearings

Check the spindle bearings for wear or damage. Replace

as needed.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Ariens String Trimmer Specifications Page 13

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens String Trimmer