Ariens 991082 ZT HD48 Specifications download pdf (Page 26)

GB - 26

ADJUSTING THE UNIT TO TRACK

STRAIGHT

Check and adjust tire pressure. Increase

pressure on side unit tracks to. DO NOT

exceed maximum recommended tire

pressure (See Specifications on page 33).

If tire pressure adjustment does not solve

tracking problem, adjust the limiter bolts on

the stop bracket (Figure 15). Front bolts

adjust forward and rear bolts adjust reverse.

Lengthen the limiter bolt (move closer to

lever) on side which is too fast.

ADJUSTING THE HEIGHT OF THE

STEERING LEVER HANDLES

The handles have three height positions

(Figure 16).

1. Shut OFF engine. Engage parking

brake. Remove the ignition key.

2. Remove the spacer, handle, and

eccentric spacer from the steering lever.

NOTE: Position the right and left handles at

the same height position.

3. Install the spacer, handle, and eccentric

spacer in the appropriate height position.

Do not tighten the nut holding the

eccentric spacer.

4. Turn the eccentric spacer until the right

and left handles are the same height.

Tighten nut.

ADJUSTING THE PARKING

BRAKE

The parking brake should not need

adjustment, however if the parking brake

does not hold the unit properly, the brake may

need adjustment.

WARNING: Prior to adjusting the

tracking of the unit, shut OFF

engine, engage parking brake,

and remove the ignition key.

Figure 15

1. Limiter Bolt

2. Jam Nut

3. Steering

Lever

4. Stop

Bracket

1

2

3

1

4

2

Figure 16

OF0004

Position # 1

Position # 2

Position # 3

1. Spacer

2. Handle

3. Eccentric

Spacer

4. Steering Lever

1

4

3

2

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Comments to this Manuals

No comments