Ariens 991082 ZT HD48 Specifications download pdf (Page 12)

GB - 12

UNIT ASSEMBLY

Package Contents:

Unit, Mower Deck and Literature Pack

Preparation Checklist

Refer to the Owner/Operator manual as

required.

1. Unpack Unit – Remove shrink wrap and

packaging materials.

2. Remove Unit From Container – Open

Bypass Valves (dump valves) (See

Moving the Unit with the Engine Off on

page 18).

Push unit from container onto a level

surface. Close the bypass valves.

3. Tires – See Specifications on page 33.

4. Seat – See Seat Adjustments on

page 15 and Service Position on

page 20.

5. Position Steering Levers – Remove

eccentric spacers and rotate steering

levers to the operating position. Reinstall

spacers. Tighten hardware securely.

See Aligning the Steering Levers

(Figure 14) on page 25.

6. Battery – Remove battery from unit and

charge (See Battery on page 23).

7. Check Engine Crankcase – Check and

add oil if needed. See Engine Manual for

specifications.

8. Fill Engine Fuel Tank – Fill fuel tank. DO

NOT OVERFILL! See Filling Fuel Tank

on page 16.

NOTE: See engine manual for fuel type.

9. Hardware – Check for loose hardware.

10. Check Safety Interlock System – Check

to see that the interlock system operates

correctly (See Safety Interlock System

on page 14).

11. Lubrication – Lubricate all fittings per

maintenance label under seat and check

hydrostat oil level (See Lubricate Unit on

page 24).

12. On 60-inch Decks: Remove the

discharge chute from the transport

position and place the discharge chute

in the operating position.

13. Level Deck – Check unit to ensure deck

level set at factory has been maintained

(See Leveling the Mower Deck on

page 30).

14. Check Function of all Controls – Ensure

unit runs and performs properly.

ASSEMBLY

WARNING: AVOID INJURY.

Read and understand entire

Safety section before proceeding.

CAUTION: Avoid injury! Explosive

separation of tire and rim parts is

possible when they are serviced

incorrectly:

• Do not attempt to mount a

tire without the proper

equipment and experience

to perform the job.

• Do not inflate the tires

above the recommended

pressure.

• Do not weld or heat a wheel

and tire assembly. Heat can

cause an increase in air

pressure resulting in an

explosion. Welding can

structurally weaken or

deform the wheel.

• Do not stand in front or over

the tire assembly when

inflating. Use a clip-on

chuck and extension hose

long enough to allow you to

stand to one side.

WARNING: FAILURE OF

INTERLOCK together with

improper operation can result in

severe personal injury.

WARNING: FAILURE OF

CONTROLS could result in death

or serious injury.

1. Steering

Levers

2. Seat

3. Mounting

Hardware

OF4110

Figure 3

1

3

2

1

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments