Ariens 985119 Specifications download pdf (Page 18)

GB - 18

IMPORTANT: Tighten and loosen the bolts in a cross

sequence as shown in Figure 16.

4. Tighten all PTO brake bolts until the springs are

solid. Back all bolts up 1/2 turn (Figure 17).

NOTE: Make sure the trunnion block is on the shipper

shaft and held in place by the dog. The dog should rest

on the spiral teeth of the clutch dog plate. Install the gas-

ket (Figure 18).

Align the splines on the quick hitch shaft with those in the

dog. Slide the quick hitch casting and PTO brake

assembly back into the place on the front of the

transmission. Install the quick hitch studs and tighten.

SLIP CLUTCH

To adjust the slip clutch:

1. Remove the attachment and lower the rear of the

tractor to the ground.

2. Carefully clean the front of the transmission.

3. Remove the quick hitch studs from the

transmission.

4. Remove the quick hitch PTO assembly and PTO

brake assembly.

NOTE: The attachment gasket must be replaced if

damaged.

5. Remove the dog and trunnion block (Figure 18).

6. Disconnect the wiring harness from the PTO brake

interlock switch.

7. Remove the shifter parts.

8. Slide the shipper shaft assembly through the top of

the advance casting.

9. Slide the clutch assembly and pinion shaft out of

the transmission (Figure 18).

10. Remove the retaining ring and slide the clutch

assembly off of the pinion shaft.

Figure 15

1. Quick Hitch Adapter 2. Quick Hitch Stud

Figure 16

Figure 17

1. PTO Brake Bolts

2. Springs

3. PTO shaft

WARNING: Stop the engine before

adjusting the slip clutch.

Figure 18

1. Shifter Parts

2. Wiring Harness

3. Shipper Shaft

4. Trunnion Block

5. Dog

6. PTO Slip Clutch

Assembly

7. Clutch Dog Plate

8. Gasket

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Ariens 985119 Specifications Page 18

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 985119