Ariens 915167-Zoom XL 54 Specifications download pdf (Page 10)

GB - 10

Tools Required

• Adjustable wrench

• 9/16" wrench

• Petroleum jelly or dielectric grease.

Unpack Unit

Remove unit and all other components from

the shipping container. Engage transmission

bypass lever (see MOVING UNIT

MANUALLY on page 16). Push unit from

container onto a level surface. Disengage

transmission bypass lever.

Connect Battery

See Battery Removal and Installation on

page 22 and perform steps 2 and 3 in the

installation section.

Place Unit in Operating Position

NOTE: The seat is shipped with the seat

positioned as far back as possible.

1. Push steering levers aside and tip seat

up.

2. Adjust the seat as needed (see

Adjusting Seat on page 15).

3. Remove hardware from top hole of the

steering lever (Figure 3). Slide steering

lever back to align slot with hole at the

top of the steering pivot arm.

NOTE: Do not tighten hardware before

reviewing ADJUSTING STEERING LEVERS

on page 23. If no adjustment is desired

tighten hardware.

4. Adjust steering levers (see ADJUSTING

STEERING LEVERS on page 23).

Place Discharge Chute in Operating

Position

Prior to operating the unit, remove the

discharge chute from the transport position

and place the discharge chute in the

operating position (figure 4).

ASSEMBLY

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: Do not operate

mower unless the discharge chute

is in the operating position.

1. Steering Lever

2. Steering Pivot

Arm

3. Steering Lever

Hardware

Figure 3

1

3

2

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments