10
INSTALL FRAME AND COVER ASSEMBLY
(FIGURE 9)
1. Position mounting plate weldment (item 13) on rear
of unit frame and on both sides install 3/8-16 x 1.00
hex bolt (item 15), .438 x 1.00 x .083 flat steel
washer (item 16) and 3/8-16 nyloc flange nut
(item 14). Do not fully tighten.
2. Install bagger frame to rear of unit with four 3/8-16 x
1.00 round head square head bolts (item 17), four
3/8-16 nyloc flange nuts (item 14) and two 3/8-16"
wing nuts (item 12). Do not fully tighten.
3. Attach pin on bagger strap (item 19) to bracket on
frame with .438 x 1.00 x .083 flat steel washer
(item 16) and .091 x 1.875 bow tie locking cotter pin
(item 18). Repeat for opposite side.
4. Install three .515 x 1.625 x .250 flat steel washers
(item 20) and bagger strap to pin on bagger frame
and fasten with .091 x 1.875 bow tie locking cotter
pin (item 18).
5. Tighten all hardware.
Figure 9
18
19
18
20
14
17
13
14
5
16
12
NOTE: Bagger cover assembly is
pre-installed on bagger frame. It is
not shown here to better illustrate
assembly steps.
Frame
Bracket
15
16
17
Comments to this Manuals