Ariens 911271-Pro21 Specifications download pdf (Page 13)

IMPORTANT:Excessivelyoxygenatedor

reformulatedfuels(fuelsblendedwith

alcoholsorethers)candamagethefuel

systemorcauseperformanceproblems.If

anyundesirableoperatingproblemsoccur,

useagasolinewithalowerpercentageof

alcoholorether.

Fuel Stabilizer

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

To add fuel to fuel tank:

1. Put unit in open or well-ventilated area.

2. Stop engine and allow to cool.

3. Clean fuel cap and surrounding area.

4. Remove cap.

IMPORTANT: See engine manual for correct

type and grade of fuel.

5. Fill fuel tank to within 1/4 in. (0.63 cm)

below bottom of filler neck with unleaded

gasoline. See SPECIFICATIONS on

page 25.

6. Replace fuel cap and tighten.

7. ALWAYS clean any spilled fuel.

MOWER SET-UP

CAUTION: DO NOT operate

mower unless either side

discharge cover or side discharge

deflector is installed. Thrown

objects may cause damage or

injury. Never operate unit with rear

door open unless grass bag is in

place.

CAUTION: If clogs or obstruction

prevents grass flow, release

engine/blade control and

disconnect spark plug wire before

attempting to clear away any

clogs.

To Bag

CAUTION: Check grass bag

frequently for wear or

deterioration. Replace worn or

damaged bag with Ariens original

equipment replacement bag only.

1. Shut off unit.

2. Remove Mulchmaster plug (Figure 11).

3. Install side discharge cover (Figure 9).

4. Lift rear door.

5. Hook grass bag frame on mounting

flange.

6. Lower rear door.

If necessary, lift rear of grass bag frame to

lock in position.

There should be no openings between bag

and mounting surface after installing bag. If

necessary, clear debris from bag mounting

surface.

Side Discharge Cover

Figure 9

Grass Bag Removal

1. Shut off unit.

2. Lift rear door.

3. Use handle to lift bag off mounting

flange.

4. Close rear door.

NOTE: Empty grass bag and clean mower

pan after each use. DO NOT allow grass

clumps or a grass coating to collect inside of

grass bag or mower pan. Remove grass bag

from mower, wash bag with hose and allow to

dry.

GB - 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Comments to this Manuals

No comments