Ariens 911271-Pro21 Specifications download pdf (Page 12)

Front and Rear Wheels

To change cutting height, move cutting height

levers one notch at a time on each wheel to

set desired height (Figure 7).

NOTE: Each wheel on mower must be set at

the same height for a level cut.

Front Wheel Wheel Adjuster

Wheel Ad

Rear Wheel

Figure 7

OPTIONAL CONTROLS

Primer Bulb

Push the primer bulb in to add fuel for easier

engine start.

Wheel Drive Control

CAUTION: Unit will move forward

at engine start if wheel drive

control is engaged. ALWAYS

release wheel drive control before

starting unit.

NOTE: Engine must be running for wheel

drive to propel unit.

To drive forward:

Slowly pull the wheel drive control toward the

handlebar until you reach a comfortable

ground speed. Hold the wheel drive control in

this position to maintain the speed.

To stop:

Release wheel drive control.

Figure 8

FILLING THE FUEL TANK

GASOLINE

IMPORTANT: ALWAYS use gasoline that

meets the following guidelines:

Clean, fresh gasoline.

A minimum of 87 octane/87 AKI (91

IRON). High altitude use may require a

different octane. Consult your engine

manual.

Gasoline with up to 10% ethanol

(gasohol) or up to 15% MTBE (methyl

tertiary butyl ether) is acceptable.

Use of any gasoline other than those

approved above may void the engine

warranty. If the pumps are not marked

for the content of alcohol or ethers,

check ethanol and MTBE levels with

the fuel supplier.

Do not modify the fuel system to use

different fuels.

Never mix oil and gasoline.

NOTE: All gasoline is not the same. If the

engine experiences starting or performance

problems after using a new gasoline, switch

to a different fuel provider or fuel brand.

GB- 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Comments to this Manuals

No comments