Ariens 911271-Pro21 Specifications download pdf (Page 21)

ENGINE/BLADE CONTROL

ADJUSTMENT

IMPORTANT: The engine and blade must

stop within 3 seconds after releasing the

control. If the engine and blade continue to

run, adjust or repair control immediately. If the

cable cannot be adjusted to stop the engine

or blade within 3 seconds, take the unit to an

authorized Ariens dealer for repairs.

NOTE: The engine/blade control must be

adjusted so the engine starts when the bail is

held against the handlebar and stops when

the bail is released. When the cable is

adjusted properly, there will be a slight

amount of slack between the bail and the

cable bracket.

To adjust engine/blade control:

1. Loosen cable nuts away from bracket.

Cable Nuts

Figure 18

2. Squeeze z-bend bracket at engine end

of cable toward front of unit and hold in

place.

f................

...... j

I

\ J

OM1040

3. Pull cable down from bracket until there

is no slack in cable.

Check here for

slack.

4. Tighten lower cable nut to 3 mm below

bracket.Release z-bend bracket.

5. Tighten upper cable nut until the adjuster

is secure on the bracket. There should

be a slight amount of slack between the

cable bracket and the engine/blade

control bail.

6. Engage engine/blade control. Measure

distance between middle of z-bend and

cable bracket. Measurement should be

as shown below.

7. If correct measurement cannot be set,

contact your local dealer.

Kawasaki Engines: 1.125"-1.375"

(2.8 cm - 3.5 cm)

........... i ......................

-\ i

0M1051

WHEEL DRIVE CONTROL

ADJUSTMENT (SELF-PROPELLED

MODELS)

See Figure 19.

NOTE: The unit should stop immediately

when the wheel drive control is released, and

the unit should not creep forward when the

wheel drive control is disengaged with the

engine running. The unit's forward speed

should increase as the wheel drive control

gets closer to the handlebar.

If the unit creeps, decrease traction and

speed. If the unit does not accelerate

smoothly or seems to slip under load,

increase the traction and speed.

GB - 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 57 58

Comments to this Manuals

No comments