Ariens 911173 Specifications download pdf (Page 22)

EN - 22

Install Drive Belt

See Figure 16.

1. Route new belt through belt channel.

2. Route belt around transmission pulley

and reinstall transmission bracket and

hardware. Rotate transmission back into

location. Loop belt over crankshaft end.

Install engine pulley with key.

3. Install belt channel guides and drive

pulley guide.

4. Install blade adapter and blade. Make

sure the blade hardware is tightened to

the proper torque. See To install blade:

on page 18.

5. Connect the wheel drive cable spring to

the transmission bracket and rotate drive

cable adjuster to properly adjust drive

cable See WHEEL DRIVE CONTROL

ADJUSTMENT on page 23. See

Figure 15.

6. Connect spark plug wire.

ENGINE/BLADE CONTROL

ADJUSTMENT

NOTICE: The engine/blade control has no

user serviceable adjustments. If releasing the

engine/blade control does not stop the engine

or blade within 3 seconds, take the unit to an

authorized Ariens dealer for repairs.

BATTERY

(911179)

NOTICE: Unit comes equipped with a

maintenance-free battery that requires no

regular maintenance except charging and

cleaning the terminals.

Remove Battery from Unit

1.Disconnect harness.

2.Remove battery cover and battery. Save

mounting hardware for installation.

Install Battery on Unit

1.Insert battery and route wire harness

through battery cover.

2.Align holes on battery cover and bag

mount; secure with previously removed

hardware.

3.Connect harness (Figure 17).

Charge Battery

NOTICE: Engine does not charge the battery.

Battery will require periodic charging to

ensure proper starting. It is recommended to

charge battery on a monthly basis for 6 hours

even if mower is not used.

IMPORTANT: DO NOT attempt to jump start

mower.

IMPORTANT: DO NOT start engine while the

charger is connected to wiring harness.

1.Connect battery charger to the wiring

harness. See Figure 17.

2.Plug charger into 120 VAC outlet.

IMPORTANT: Battery charger supplied with

unit is for 120 volt Alternating Current (AC)

outlets only.

3.Charge for 16 – 24 hours.

IMPORTANT: DO NOT overcharge battery.

Disconnect battery after 24 hours.

WARNING: AVOID INJURY.

Read and understand the entire

Safety section before proceeding.

WARNING: Battery posts,

terminals and related accessories

contain lead and lead

compounds, chemicals known to

the State of California to cause

cancer and reproductive harm.

Wash hands after handling.

Figure 17

1. Battery Cover

2. Wire Harness

2

1

Connect battery charger here.

Figure 18

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments