Ariens 911173 Specifications download pdf (Page 20)

EN - 20

SERVICE POSITION

Put unit into service position for easy access

to bottom of deck.

1. Place unit on a flat, level surface.

2. Disconnect spark plug wire.

3. Remove fuel cap.

4. Place a piece of plastic bag over the

opening and tighten cap securely.

5. Remove discharge chute if installed.

6. Tip unit onto right side.

Make sure unit is secure and will not tip

over.

IMPORTANT: Remove plastic from fuel cap

after unit is upright and service is complete.

HANDLEBAR HEIGHT

(911173)

To adjust (Figure 13):

1. Remove hardware from lower handlebar

mounting hole.

2. Rotate the handlebar to the desired

position and align the mounting holes

with the holes in the handlebar upright.

3. Secure handlebar with hardware

removed in step 1.

NOTICE: To fold handlebar flat for storage,

remove the hardware from the lower

handlebar mounting holes, rotate the

handlebar forward, and then tighten the

hardware in the holes on the handlebar.

HANDLEBAR HEIGHT

(911175, 179)

To adjust (Figure 14):

1. Push the engine/blade control forward

slightly and rotate handlebar to the

desired position.

NOTICE: To fold handlebar flat for storage,

push the engine/blade control forward slightly

and rotate handlebar forward and down

toward mower frame.

SERVICE AND ADJUSTMENTS

CAUTION: AVOID INJURY. Read

and understand the entire

Safety

section before proceeding.

CAUTION: Avoid fuel spills. Follow

steps below to help prevent fuel

spills. If fuel leaks into air cleaner,

replace air cleaner. ALWAYS

clean up any spilled fuel.

Figure 13

1. Handlebar

2. Mounting Hardware

2

1

Figure 14

1. Engine/Blade Control

1

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Comments to this Manuals

No comments