Ariens SNO-THRO 937 User Manual download pdf (Page 10)

Operation (Continued)

starting

CAUTION: DO NOT attempt to start

your engine at this time. Thoroughly

read this entire Owner's Manual and

engine manufacturers operating

instructions first.

NOTE: Try out each control without running engine

to see how they work and what they do.

Figure 3: Engine Ignition

Engine Ignition

WARNING: If equipment vibrates

abnormally disengage attachment, stop

engine at once, and remove key.

Abnormal vibration is a warning of

trouble. Repair any damage before

restarting unit.

CAUTION: Turn Key "OFF" and remove

it before attempting any maintenance,

adjustment or leaving unit unattended.

To start engine, place Key in Switch and turn it

clockwise to "RUN" position.

Choke

Pull choke control to “Choke" position. When engine

has started, open choke gradually.

NOTE: A warm engine requires less choking than a

cold engine.

Primer Bulb

Push primer bulb two or three times when engine is

cold. When temperatures are below -15 degrees

Fahrenheit, additional priming may be needed.

Recoil Starter

WARNING: To prevent discharge

toward operators' starting position,

always turn discharge chute straight

ahead for starting unit.

Stand to right of unit. Grasp starter handle and pull

rope out slowly until it pulls harder, this is

compression stroke, let rope rewind slowly.

Then pull rope with a rapid continuous full arm stroke.

Let rope rewind slowly.

IMPORTANT: DO NOT let starter handle snap

against bracket.

Repeat above instructions until engine starts. (Refer

to engine manufacturers instructions).

Electric Starter (Optional Accessory)

Connect power cord to switch box first then plug

other end into 120 volt AC receptacle.

Push Starter Button to crank engine.

IMPORTANT: This electric starter is not equipped

with a thermal cut-out switch. DO NOT crank engine

for more than a total of 20 seconds without allowing

electric starter to cool down for 10 minutes. Failure

to do this can severely damage electric starter.

When engine starts, release starter button and

disconnect power cord from receptacle first, then

from switch box.

CAUTION: DO NOT overload machine

capacity by attempting to clear snow at

too fast a rate.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments

Ariens SNO-THRO 937 User Manual Page 10

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens SNO-THRO 937