Ariens ProZoom 99480600-1952S Specifications Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 44
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
GB - 12
Setting Cutting Height
HOLE LOCATIONS
To adjust the rear height of cut, use the chart above and match the
hole locations on the chart up to the hole locations on the picture.
To adjust the front height of cut, use the chart above and insert the
number of C-spacers to correspond to the number on the chart to
achieve the height of cut you desire.
NOTE: Rake is described as the amount that the rear of the deck is
above the front of the deck. Your best cut will occur when you have
at least some rake on the deck.
Testing Safety Systems
The safety systems installed on your machine should be checked
before each machine use. Be sure you have read the machine
operator manual and are completely familiar with the operation of
the machine before performing these safety system checks.
Use the following checkout procedures to check for normal
operation of machine.
If there is a malfunction during one of these procedures, do not
operate machine. See your authorized dealer for service.
Perform these tests in a clear open area. Keep bystanders away.
NOTE: Before setting cut height, ensure the tires are all set at
the correct tire pressures.
Rear of Deck Front Casters
Rear Deck Nominal Height C-Spacers C-Spacers Height of Cut Deck Rake
Hole Position Top Bottom (inches) (inches)
14.5064.50
14.51540.5
14.5243.51
14.533
NA
14.542
14.551
14.560
23.506
NA
23.515
23.5243.50
23.53330.5
23.5422.51
23.551
NA
23.560
32.506
NA
32.515
32.524
32.533
32.5422.50
32.55120.5
32.5601.51
CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.
Move the machine to an outside area before running the
engine.
Do not run an engine in an enclosed area without
adequate ventilation.
Connect a pipe extension to the engine exhaust pipe
to direct the exhaust fumes out of the area.
Allow fresh outside air into the work area to clear the
exhaust fumes out.
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Comments to this Manuals

No comments