Ariens 1332 Specifications download pdf (Page 21)

GB - 21

Charge Battery

Battery Electrolyte First Aid

• External Contact: Flush with water.

• Eyes: Flush with water for at least 15 minutes and get

medical attention immediately!

• Internal Contact: Drink large quantities of water.

Follow with Milk of Magnesia, beaten egg or vegetable

oil. Get medical attention immediately! DO NOT induce

vomiting!

IMPORTANT: DO NOT fast charge. Charging at a higher

rate will damage or destroy battery.

IMPORTANT: ONLY use an automatic charger designed for

use with your battery. ALWAYS follow information provided

on battery and battery charger. Contact battery and charger

manufacturers for detailed instructions.

1. Remove battery cover.

2. Disconnect negative (–) cable first, then positive (+)

cable (Figure 15).

3. Remove battery.

4. Place battery on bench or other well-ventilated area.

5. Connect positive (+) lead of charger to positive (+)

terminal, and negative (–) lead to negative (–) terminal.

6. Charge battery according to charger and battery

manufacturers’ instructions.

7. Reinstall battery on unit and connect positive (+) cable

first, then negative (–) cable.

It may be possible to recharge the battery by jump starting

the unit and allowing the engine to run.

Jump Start

The unit used for jump starting should have a 12-volt battery

with at least 500 cold cranking amperes, and a negatively

grounded system.

1. Ensure battery is not frozen. If the fluid is frozen,

remove battery from unit and allow it to thaw before

charging.

2. Connect the positive (+) jumper cable to the positive

terminal of the discharged battery.

3. Connect the other end of the same jumper cable to the

positive (+) terminal of the booster battery.

4. Connect one end of the second jumper cable to the

negative (–) terminal of the booster battery.

5. Make the final jumper cable connection to the engine

block or the furthest ground point away from the

discharged battery.

6. Start engine (See Starting and Shut Off on page 12). If

engine will not start after several tries, unit or battery

may need service.

7. After engine starts, leave cables connected for one to

two minutes.

8. Disconnect cables in reverse order.

9. Operate unit normally to charge battery.

32" AND 36" BELT REPLACEMENT

1. Stop engine, remove key and wait for all hot parts to

cool.

2. Set deck to the fourth cutting height.

3. Remove deck cover.

4. Remove deck idler spring.

5. Remove belt from deck pulleys and mower clutch

sheave.

6. Install new belt.

7. Replace idler spring.

8. Replace deck cover and secure.

WARNING: FROZEN BATTERIES CAN

EXPLODE and result in death or serious injury.

DO NOT charge a frozen battery. Let the

battery thaw before charging.

1. Positive terminal

2. Negative terminal

3. Battery

OF1670

Figure 15

WARNING: Make sure cables are clear of any

moving engine parts before starting engine.

Figure 16

OG1390

1. Idler Spring

2. Deck Pulley

3. Mower Clutch

Sheave

4. Belt

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Ariens 1332 Specifications Page 21

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 1332