Ariens 1332 Specifications download pdf (Page 18)

GB-18

ADJUST BRAKES

NOTE: The traction belt must disengage as the brake starts

to engage.

1. Turn off the engine, remove the key and allow unit to

cool.

2. If brakes do not disengage fully when traction belt is

engaged, the brakes are too tight. Loosen the wing nut

(Figure 9).

3. If brakes do not engage fully when traction belt is

disengaged, the brakes are too loose. Tighten the wing

nut.

4. Start engine and test in low gear for proper brake

engagement.

REPLACE TRACTION BELTS

1. Turn off the engine, remove the key and allow unit to

cool.

2. Release the steering levers (988100, 101, 102, 103,

104, 110, 112).

3. Raise the rear of the unit so that the drive wheels are

off the ground.

4. Remove traction belt guard.

5. Remove clutch idler pulley spring (Figure 10).

6. Remove hair pin and clevis pin holding steering control

rod to wheel clutch arm weldment.

Figure 8

1. Hair Pin

2. Clevis Pin

3. Clevis

4. Steering Lever

5. Steering Control Rod

6. Pivot Bar

7. Control Lever

8. Control Stop Lock

Lever

OG0752

2-1/2 - 3"

(6.35 - 7.6 cm)

2-1/2 - 3"

(6.35 - 7.6 cm)

WARNING: AVOID INJURY. An extension

spring, when extended, stores energy and

can be dangerous. Always use tools

specifically designed for installing or

removing an extension spring. Always

compress or extend springs slowly.

Wing Nut

Brake Rod

Brake Band

Figure 9

OG1350

Note: Some components removed

for clarity.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comments to this Manuals

No comments

Ariens 1332 Specifications Page 18

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 1332