Ariens 915155-Zoom 42 Carb Specifications download pdf (Page 24)

GB - 24

3. Slowly release idler arm until idler pulley

rests firmly against PTO belt.

4. Install belt covers on mower deck.

NOTE: Ensure that belt is still positioned in

the groove of the sheave after belt covers are

installed.

REPLACING HYDROSTATIC BELT

Remove

(Figure 20)

1. Remove PTO belt (see REPLACING

PTO BELT on page 23).

2. Disconnect idler spring.

3. Remove hydrostatic belt from

hydrostatic transmission pulleys, drive

pulley, and idler.

Install

(Figure 20)

1. Install hydrostatic belt on idler, drive

pulley, and hydrostatic transmission

pulleys.

2. Connect idler spring.

3. Install PTO belt (see REPLACING PTO

BELT on page 23).

Short Term Storage

IMPORTANT: NEVER clean unit with high-

pressure water or store unit outdoors.

Remove all dirt, grease, leaves, etc. Store in

a clean dry area.

Inspect unit for signs of wear or damage.

Ensure all fasteners are properly tightened.

Long Term Storage

Follow all instructions under Short Term

Storage.

Remove and fully charge battery. Store in a

clean dry area.

Refer to Engine Manual for the proper engine

storage procedures.

Touch up all scratched or chipped paint

surfaces.

Fuel System

Gasoline left in the fuel system for extended

periods without a stabilizer will deteriorate,

resulting in gum deposits in the system.

These deposits can damage the carburetor

and the fuel hoses, filter and tank. Prevent

deposits from forming in the fuel system

during storage by adding a quality fuel

stabilizer to the fuel. Follow the

recommended mix ratio found on the fuel

stabilizer container.

To treat the fuel system for storage:

1. Add fuel stabilizer according to

manufacturers’s instructions.

2. Run engine for at least 10 minutes after

adding stabilizer to allow it to reach the

carburetor.

NEVER store the engine with fuel in the fuel

tank inside of a building with potential

sources of ignition.

CAUTION: Use care when

releasing idler spring tension.

Keep body parts well away from

idler when performing this

operation.

Figure 20

1

1. Hydrostatic Belt

2. Hydrostatic

Transmission

Pulley

3. Idler

4. Idler Spring

2

2

3

4

STORAGE

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

Comments to this Manuals

No comments