Ariens 915155-Zoom 42 Carb Specifications Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 33
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
GB - 22
ADJUSTING STEERING LEVERS
(Figure 15)
IMPORTANT: Adjust each steering lever
equally.
NOTE: When adjusting steering levers for the
first time it is recommended that you make
adjustments in the following order.
1. Adjust Steering Lever Height
1. Remove mounting hardware that
attaches the handlebars to the upper
control arm. Move handlebar up or down
until the handlebar mounting holes are
aligned with the prefered adjustment
holes.
2. Install mounting hardware and tighten.
2. Adjust Steering Lever Width
1. Loosen hardware at the base of the
lower control arm item 5.
2. Rotate eccentric spacer to move the
levers away from or closer to the
operators position (figure 16).
3. Adjust Steering Lever Forward or
Backward
1. Loosen, do not remove, the bolts
securing the handlebar to the upper
control arm.
2. Slide steering lever forward or backward
to desired position and tighten bolts.
NOTE: Tigthen upper bolt first.
Forward Speed Adjustment
(Figure 17)
NOTE: Reverse speed cannot be adjusted. If
unit tracks excessively left or right in reverse,
see your Dealer for repair.
IMPORTANT: The unit should track within
2 feet (0.61 m) of a straight line for 30 feet
(9.14 m).
The travel of the steering levers may need
adjustment if the unit turns to the right or left
when both steering levers are pushed as far
forward as possible.
NOTE: The side the unit turns toward
indicates that the wheel on that side is turning
slower than the other wheel. Either the wheel
that is turning faster needs to slow down or
the wheel that is turning slower needs to
speed up to allow the unit to travel in a
straight line.
1. Determine which way the unit turns.
2. Loosen jam nut on the adjustment bolt.
3. Adjust speed by:
Turning adjustment bolt clockwise to
decrease steering lever travel.
Turning adjustment bolt
counterclockwise to increase steering
lever travel.
4. Tighten the jam nut.
Figure 15
2
3
1
1. Handlebar
2. Upper Control Arm
3. Adjustment Holes
4. Eccentric Spacer
5. Mounting Hardware
6. Lower Control Arm
5
Adjustment 2
Adjustment 1
Adjustment 3
4
6
Figure 16
Rotate this end away from the operator
position to move the steering levers out.
Rotate this end away from the the operator
position to move the steering levers in.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Comments to this Manuals

No comments