Ariens 927 Specifications download pdf (Page 25)

GB - 25

SHEAR BOLTS

IMPORTANT: Use only Ariens shear bolts for

replacement. Use of any other type of shear

bolt may result in severe damage to unit. See

SERVICE PARTS on page 35.

Occasionally a foreign object may enter the

auger/impeller housing and jam the auger,

breaking shear bolts (Figure 25) which

secure the auger to the shaft. This allows

auger to turn freely on the shaft which may

help prevent damage to gear drive.

For Replacement:

1. Align shear bolt holes in auger with

shear bolt holes in the shaft.

2. Drive shear bolt through hole (if shear

bolt was broken this will drive remaining

part from shaft).

3. Secure shear bolt with nut.

REMOTE WHEEL LOCK (921005)

If remote wheel lock does not lock or unlock:

1. Place unit in service position (see

Service Position on page 22).

2. Loosen jam nuts on cable. Make sure

the bottom jam nut is loosened enough

to remove slack from cable (Figure 26).

3. Pull the cable adjuster to remove slack

between the cable adjuster and the

extension spring and hold the cable

adjuster in position while finger

tightening the top jam nut against the

bracket. Do not extend the spring or

engage the mechanism.

4. Tighten the bottom jam nut.

5. Check function of remote wheel lock. If

wheel lock does not function properly,

remove bottom cover to check cable

slack.

6. Repeat steps 2 – 4 while watching cable

to remove slack.

7. Check function of remote wheel lock. If

wheel lock does not function properly,

take the unit to Dealer for repairs.

DEFLECTOR REMOTE (921004,

006, 007, 008, 009)

Deflector must stay in selected position while

throwing snow.

If deflector does not stay in set position:

1. Tighten nut beneath control panel to

increase pressure on deflector control

(Figure 27).

If deflector does not follow full range of travel:

1. Push deflector remote all the way

forward.

2. Loosen adjusting nuts on cable support

bracket underneath the dash panel

(Figure 27).

3. To adjust the deflector lower:

Slide cable down. Tighten bottom nut.

Figure 24

2

1

OS0482

1. Runner

2. Runner Hardware

Figure 25

1. Auger

2. Shear Bolts

OS7150

1

2

Figure 26

1. Top Jam Nut

2. Bottom Jam Nut

3. Cable Adjuster

1

2

No Slack

OS7170

3

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Comments to this Manuals

No comments