Ariens 931015 S-18 User Manual download pdf (Page 3)

DECALS FOR HYDROSTATIC MODELS 931015, 931016, 931017, & 931018

MV'cziRa

(LEFT SIDE

DECAL SHOWN)

78464 L.H. S-18H

78463 R.H. S-18H

78415 L.H. S-16H

78414 R.H. S-16H

78413 L.H. S-14H

78412 R.H. S-14H

78411 LH. S-12H

78410 R.H. S-12H

78278

AR tIFT

78391

COMPLIANCE WITH CANADIAN RADIO INTERFERENCE REGULATIONS CERTIFIED

_______________

REPLACE SPARK PLUG WITH RESISTOR SPARK PLUG ONLY !

______________

CERTFIE CONFORME AU REGLEMENT CANADIEN SUR LE BROUILLAGE RADIOELECTRIQUE

REMPLACER LA ROUGIE PAR UNE ROUGIE A RESISTANCE SEULEMENT I

78400

(UNDER HOOD NEXT TO SPARK PLUG)

BE AWARE OF SAFETY DECALS

15. When using any attachments, never direct discharge of

material toward bystanders nor allow anyone near the vehicle

vyhile in operation.

16. Handle gasoline with care—it is highly inflammable.

a. Use approved gasoline container.

b. Never remove the cap of the fuel or add gasoline to a

running or hot engine, or fill the fuel tank indoors. Wipe

up spilled gasoline.

c. Open doors if the engine is run in the garage—exhaust

fumes are dangerous. Do not run the engine indoors.

17. Keep the vehicle and attachments in good operating con

dition, arid keep safety devices in place.

18. Keep all nuts, bolts, and screws tight to be sure the equip-

ent is in safe working condition.

19. Never store the equipment with gasoline in the tank inside a

building where fumes may reach an open flame or spark. Al

low the engine to cool before storing in any enclosure.

20. To reduce fire hazard, keep the engine free of grass, leaves,

or excessive grease.

21. The vehicle and attachments should be stopped and in

spected for damage after striking a foreign object, and the

damage should be repaired before restarting and operating

the equipment, see numbers 6 & 7 opposite page.

22. Do not change the engine governor settings or overspeed the

engine.

23. When using the vehicle with mower, proceed as follows:

a. Mow only in daylight or in good artificial light.

b. Never make a cutting height adjustment while the engine

is running if the operator must dismount to do so.

c. Shut the engine off when removing the grass catcher or

unclogging chute.

d. Check the blade mounting bolts for proper tightness at

frequent invervals.

24. Check the grass catcher bags frequently for wear or de

terioration. Replace with new bags for safety protection.

Page 3

1 2 3 4 5 6 7 8 ... 41 42

Comments to this Manuals

No comments

Ariens 931015 S-18 User Manual Page 3

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 931015 S-18