Ariens Sno-Thro 921001 - ST824E User Manual download pdf (Page 9)

GB - 9

NOTE: After the chute rod has been inserted through

the hex hole in the control assembly, placing the unit in

the service position (see Service Position on page 18)

will ease alignment and installation of the hair pin.

8. Secure the chute rod to the control assembly with

the hair pin removed in step 6. Insert the hair pin

with the loop end to the left of the chute rod so the

control assembly follows a full range of travel.

9. Insert the chute lock cable fitting into the bracket

on the chute pedestal, and then connect the

chute lock cable to the lock teeth by fitting the

cable ball end into the slot on the lock teeth. See

Figure 10.

NOTE: Press down on lock teeth with your finger to

align the cable ball end with the slot (Figure 10).

10. Replace the gear cover removed in step 4.

IMPORTANT: Rotate the discharge chute to the left

when tightening the pedestal hardware to ensure

clearance between the discharge chute and the belt

cover.

11. Tighten pedestal hardware to 15 – 31 lbf-ft (20 –

42 N•m).

12. Make sure the discharge chute rotates left and

right when you push the discharge chute control

lever left and right.

Install Discharge Chute and Discharge Chute

Crank (921001)

(Figure 11)

1. Grease underside of discharge chute ring (if not

already greased).

2. Remove mounting hardware from auger housing.

3. Install discharge chute over opening in the auger

housing. Finger tighten the mounting hardware

removed in step 2.

NOTE: Leave discharge chute pedestal loose to help

install the chute rod and connect it to the control

assembly.

4. Insert the short end of the chute rod into the hole

in the front of the control panel.

5. Connect the chute crank to the pinion gear on

chute with spring clip.

IMPORTANT: Rotate the discharge chute to the left

when tightening the pedestal hardware to ensure

clearance between the discharge chute and the belt

cover.

6. Tighten pedestal hardware to 15 – 31 lbf-ft (20 –

42 N•m).

Deflector Remote (921002, 003, 004)

Connect the cable end to the cable anchor on the

discharge deflector before clipping the cable to the

cable bracket on the discharge chute.

1. Route deflector remote cable along the left side of

the chute pedestal.

Figure 9

1.Chute Rod

2.Gear Cover

3.Control Assembly

4.Hair Pin

OS7432

921002, 003, 004

Figure 10

OS7271

Figure 11

1.Chute Rod

2.Gear Cover

3.Control Panel

4.Hair Pin

OS7061

921001

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comments to this Manuals

No comments

Ariens Sno-Thro 921001 - ST824E User Manual Page 9

Comments to this Manuals

Related products and manuals for Cars Ariens Sno-Thro 921001 - ST824E