Ariens Sno-Thro 921001 - ST824E User Manual download pdf (Page 24)

GB - 24

ATTACHMENT CLUTCH/BRAKE

ADJUSTMENT

(Figures 33, 34 and 35)

Remove Attachment Cable Slack

1. Remove the belt cover.

2. Loosen jam nut on cable adjustment barrel, and

then turn the adjustment barrel up or down to

lengthen or shorten cable and remove all cable

slack. See Figure 33.

3. With the attachment clutch disengaged, check

that the attachment idler arm lightly touches the

frame. See Figure 34.

4. Tighten jam nut on the adjustment barrel.

Check Attachment Idler Arm Roller Clearance

1. Place the unit into the service position. Remove

the bottom cover.

2. With the clutch lever engaged, check the

clearance between the frame and plastic roller on

the lower end of the attachment idler arm. See

Figure 35.

• If roller is 1/2 in. (12.7 mm) or more from frame,

go to Adjust the Attachment Clutch Cable Spring

Extension on page 25.

• If roller is less than 1/2 in. (12.7 mm) from frame,

loosen idler adjustment nut and move idler closer

to the belt. Tighten adjustment nut and recheck

the roller clearance.

IMPORTANT: IMPROPER ADJUSTMENT

could result in unexpected movement of

auger and impeller causing death or serious

injury. Auger / impeller must stop within 5

seconds when Attachment Clutch/Impeller

Brake lever is released.

Figure 32

1. Shift Rod

2.Adjustment Pivot Pin

3. Speed Selector Lever

4. Hairpin

OS7186

Figure 33

1.Adjustment Barrel

2.Jam Nut

OS7182

OS7184

Figure 34

OS7194

With the attachment clutch disengaged, check

the attachment idler arm position here. The

attachment idler arm should lightly touch the

frame.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Comments to this Manuals

No comments

Ariens Sno-Thro 921001 - ST824E User Manual Page 24

Comments to this Manuals

Related products and manuals for Cars Ariens Sno-Thro 921001 - ST824E