Ariens Sno-Thro 920001- ST624E User Manual download pdf (Page 19)

GB - 19

NOTE: To gain belt clearance, remove swing gate

spacer (Figure 22) so drive plate can be slid over until

finger is out of frame and drive plate can swing past

stop hole in frame. See Figure 23.

2. Pull idler away from traction drive belt and

remove belt from idler, crankshaft pulley and

driven pulley (it may be necessary to turn

crankshaft pulley using recoil starter handle).

3. Replace traction drive belt.

4. Swing drive plate toward friction disc to slide

finger into stop hole in frame. Reinstall swing gate

spacer.

NOTE: Make sure drive plate spring remains

connected to the frame and drive plate.

5. Replace attachment drive belt (See Replace

Attachment Drive Belt on page 18).

ATTACHMENT CLUTCH/BRAKE

ADJUSTMENT

Remove Attachment Cable Slack

1. Remove the belt cover.

2. Loosen jam nut on cable adjustment barrel, and

then turn the adjustment barrel down to shorten

cable and remove all cable slack. See Figure 24.

3. With the attachment clutch disengaged, check

that the attachment idler arm lightly touches the

frame. See Figure 25.

Figure 22 OS8069

1.Swing Gate Spacer

2.Swing Gate Finger

3. Drive Plate

Figure 23

OS8068

1.Swing Gate

2.Swing Gate Finger

3. Drive Plate

WARNING: IMPROPER ADJUSTMENT

could result in unexpected movement of

auger and impeller causing death or serious

injury. AUGER / IMPELLER MUST STOP

within 5 seconds when Attachment

Clutch/Impeller Brake Lever is released.

WARNING: Adjustment procedure requires

the engine to be run with the belt cover off.

AVOID INJURY. Read and understand the

entire Safety section before proceeding.

Figure 24

1. Attachment Clutch

Cable

2.Cable Adjustment

Barrel

3.Jam Nut

OS8070

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Ariens Sno-Thro 920001- ST624E User Manual Page 19

Comments to this Manuals

Related products and manuals for Cars Ariens Sno-Thro 920001- ST624E