Ariens Sno-Thro 920001- ST624E User Manual download pdf (Page 15)

GB - 15

Wheels must stop quickly when traction drive clutch

lever is released.

If clutches do not engage or disengage properly, adjust

or repair before operation (see Attachment

Clutch/Brake Adjustment on page 19 and Traction

Drive Clutch Adjustment on page 21).

CHECK CLUTCH SPRING ADJUSTMENT

Make sure the attachment clutch and traction drive

clutch are adjusted to the range specified in

Attachment Clutch/Brake Adjustment on page 19

andTraction Drive Clutch Adjustment on page 21.

CLEAN ENGINE

Refer to Engine Manual for detailed instructions.

CHECK ENGINE OIL

The engine crankcase oil should be checked every 5

hours of operation. Oil level MUST be maintained in

safe operating range on dipstick at all times or engine

damage will result (See Engine Manual).

Park unit on a level surface. Refer to Engine Manual for

detailed instructions.

CHANGE ENGINE OIL

Change oil after first 2 hours of operation, thereafter

change oil every 25 hours (more often if required).

Refer to Engine Manual for detailed instructions.

Run engine just prior to changing oil. Warm oil will flow

more freely and carry away more contamination.

Remove the oil drain plug from the rear of the unit and

tip the unit back to help drain all the oil.

CHECK TIRE PRESSURE

Keep tires at pressure listed on the tire sidewall. (see

Check Tire Pressure on page 8).

CHECK AUGER GEARCASE

IMPORTANT: Proper oil level must be maintained.

Gear cases are filled to the correct level at the factory.

Unless there is evidence of leakage, no additional

lubricant should be required. Check oil level each

season or every 25 hours of operation.

To ensure adequate lubricant level:

1. Remove filler plug (Figure 12). Lubricant must be

at least up to bottom of lubricant filler hole with

unit resting on a level-surface.

2. Add lubricant if required. Allow oil to drain to level

of plug and replace plug.

IMPORTANT: Use only Ariens special gear lubricant

L-2 (Part Number 00008000). Gearcase filler plug may

require an application of Loc-Tite® 565 thread sealant

with repeated servicing.

GENERAL LUBRICATION

IMPORTANT: Wipe each fitting clean before and after

lubrication. Do not wipe gearcase filler plug; wiping the

gearcase filler plug may remove thread sealant and

cause leaks.

IMPORTANT: DO NOT allow grease or oil to get on

friction disc, friction plate or belts.

NOTE: Apply Ariens Hi-Temp Grease or equivalent to

the lubrication fittings. See SERVICE PARTS on

page 23.

Sno-Thro should be lubricated (Figure 13) at beginning

of season or every 25 operating hours.

Auger Shaft

NOTE: To grease auger shaft, remove shear bolt nuts,

and shear bolts. Apply grease at the grease zerks and

then turn the auger assemblies on the auger shaft.

Replace shear bolts per instructions in Shear Bolts on

page 16.

Figure 12

1.Auger Gearcase

2.Filler Plug

OS1870

OS8050

Grease

Figure 13

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments

Ariens Sno-Thro 920001- ST624E User Manual Page 15

Comments to this Manuals

Related products and manuals for Cars Ariens Sno-Thro 920001- ST624E