Ariens Sno-Thro 920001- ST624E User Manual download pdf (Page 14)

GB - 14

To clear an area, run unit in an overlapping series of

paths. For large areas, start in the middle and throw

snow to each side, so snow is not cleared more than

once.

ALWAYS direct snow away from area to be cleared and

with direction of the wind.

TRAVELING

To travel from one work area to another:

1. Set Throttle to Slow or Part-Throttle position.

2. Press down on handlebars enough to raise front

of unit slightly off surface.

3. Engage wheel drive clutch without engaging

attachment drive clutch.

TRANSPORT

ALWAYS shut off engine, remove key, and close fuel

shut-off valve when transporting unit on a truck or

trailer.

Use extra care when loading or unloading unit onto

trailer or truck.

Secure unit chassis to transport vehicle. NEVER

secure from rods or linkages that could be damaged.

DO NOT transport machine while engine is running.

Ariens Dealers will provide any service or adjustments

which may be required to keep your unit operating at

peak efficiency. Should engine service be required,

contact an Ariens dealer or an authorized engine

manufacturer's service center.

SERVICE POSITION

Place unit on a flat level surface. Tip unit forward onto

front of auger housing for service. Ensure unit is secure

and will not tip over. Strap and clamp onto bench if

needed.

MAINTENANCE SCHEDULE

The chart below shows the recommended

maintenance schedule that should be performed on a

regular basis. More frequent service may be required.

* After first five hours of operation.

** After first two hours of operation.

CHECK DUAL HANDLE INTERLOCK

Without the engine running, press down (engage) both

clutch levers. Release attachment clutch lever.

Attachment clutch should remain engaged until traction

clutch lever is released, then both clutches must

disengage.

CHECK FASTENERS

Make sure all hardware is tightened properly.

CHECK CLUTCH OPERATION

Auger / impeller must stop within 5 seconds when

attachment clutch/impeller brake lever is released.

MAINTENANCE

WARNING: AVOID INJURY. Read and

understand the entire Safety section before

proceeding.

WARNING: Before tipping unit up onto

housing, remove fuel so no spills will occur.

Ensure unit is secure and will not tip over

during maintenance.

Figure 11

Service Position

OS8045

MAINTENANCE SCHEDULE

Service Performed Each Use Every 5

hrs.

Every 25

hrs.

Yearly

Check Dual Handle

Interlock

•

Check Fasteners •

Check Clutch

Operation

•

Check Clutch Spring

Adjustments

•

Clean Engine •

Check Engine Oil •

Change Engine Oil

•

Check Tire Pressure •

Check Auger

Gearcase

••

General Lubrication • •

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments

Ariens Sno-Thro 920001- ST624E User Manual Page 14

Comments to this Manuals

Related products and manuals for Cars Ariens Sno-Thro 920001- ST624E