Ariens 991800-ProZoom 2352S Specifications download pdf (Page 9)

Donotattemptto serviceatireunlessyouhavetheproper

equipmentandexperienceto performthejob.Ifyouarenot

qualifiedto maketherepairs,taketheunitto yourAriens

dealeroraqualifiedrepairservice.

Whenseatingtirebeadsontherims,neverexceed2,4bar

(35p.s.i.)orthemaximuminflationspecifiedonyourtires.

Inflationbeyondthismaximumpressuremaybreakthe

bead,oreventherim,withdangerousexplosiveforce.

Replacement Parts

Where replacement parts are necessary for periodic

maintenance and servicing, genuine Ariens replacements

must be used.

Ariens does not claim responsibility for installation of

unapproved parts and/or accessories or damages as a

result of their use.

TRANSPORTING

Disengage power to the attachments when in transport or

not in use.

Do not tow this machine. Use a truck or trailer to transport on

public roads.

Do not use this machine on public roads.

WARNING: AVOID INJURY! Read and

understand entire Safety Section before

proceeding.

UNPACK UNIT

Remove all packing materials and hardware and literature

packages. Discard J hook used with strapping as it is not

needed for mower operation.

SETUP INSTRUCTIONS

Ariens mowers are shipped partially assembled. After

uncrating the power unit and mower deck, initial setup is

required.

IMPORTANT: During the unpacking of the crate all goods

should be matched against the packing list and all shortages

or damages should be noted and reported to the carrier

immediately.

Steering Controls

1. The steering control levers have been lowered for

shipping. Remove the loose 3/8-16 x 1.50" bolts from

the handles and reinstall them in the location shown.

Adjust the handles to fit your comfort area.

Install bolt here.

Figure 3

Seat Setup

1. Remove the 5/16" flat washers and lock nuts from the

four studs protruding from the bottom of the seat.

2. Route the seat switch connector through the opening

the in the seat plate and plug the connector into the

seat switch.

Install the seat on the seat plate with the 5/16" flat

washers and lock nuts removed in step 1. Secure the

p-clip on the wiring harness to the left front seat stud

so the harness gets routed as shown in Figure 4.

Plug harness into

seat switch.

Bottom

P-Clip

S_at Plate

Figure 4

Battery

The battery supplied with the mower is sealed, it will not be

necessary to activate it.

1. Connect the red positive cable to the positive (+) side

of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut. Cover

terminal with rubber boot.

2. Connect the black negative cable to Negative ( - ) side

of battery. Use 1/4 x 5/8" bolt and 1/4" Iocknut.

If the engine does not turn over by turning the ignition

switch, it may be necessary to charge the battery, see

Charging the Battery on page 22.

GB - 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 76 77

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 9

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S