Ariens 991800-ProZoom 2352S Specifications download pdf (Page 13)

Ignition Switch

Operate the ignition switch with the removable key. The

switch has three positions: Off (1), Run (2) and Start (3). To

start the engine, turn the key to Start, and then release to

Run. To stop the engine, turn the key to Off.

NOTE: DO NOT operate starter more than 10 seconds at a

time. If the engine does not start after 10 seconds allow the

starter to rest 30 seconds before trying again. If engine will

not start, see Troubleshooting on page 30 or refer to Engine

Manual.

Choke Control

Pull the choke lever out to start a cold engine. Push the

choke lever in once the engine starts and warms.

OE3250

Throttle Lever

The throttle lever changes the engine

speed. Move the throttle lever forward

to Fast (1) to increase engine speed.

Move the lever rearward to Slow (2) to

decrease engine speed.

Power Take Off (PTO) Switch

ON OFF

Power take off (PTO) switch engages and

disengages the mower blades.

Pull the power take off (PTO) switch to "On"

position to engage mower blades.

Push the power take off (PTO) switch to "Off"

position to disengage mower blades.

NOTE: The engine will not start unless the steering control

levers are in the neutral position, the PTO switch is in the

"Off" position and parking brake is set.

OE3255

Parking Brakes

Place the steering control levers in the

neutral position and push them out into the

slots to engage the parking brake for each

side.

OE3385

Move the steering control levers in towards

the center to release the parking brakes.

Deck Lift Lever

Deck lift lever raises and lowers mower deck for mowing or

transport.

Transport:

Push deck lift lever all the way forward until lift lock engages.

To release the lock, push the pedal forward, pull back on the

transport lock handle, and slowly release the lift lever.

DANGER: Before raising the deck to the

transport position, insure the PTO is

disengaged and the steering control levers are

in the park position.

Cutting Height

To change the cutting height, raise the mower deck into the

transport position. Turn the Deck Height Adjust Dial until the

desired cutting height is shown and then lower the deck to

the cutting position.

The mower can be adjusted to mow from 1.5" - 5.5"

(38 - 140 mm) height of cut. Grass mowing height should be

determined by encountered conditions and personal

preferences.

The following recommendations are provided as a guide for

cutting height selection.

Lawns = 1.5 - 3" (38 - 76 mm)

Field Cutting = 3 - 5.5" (76-140 mm)

\ Deck Height

ust Dial

Deck Lift Lever

Figure 8

Seat Adjustments

WARNING: Make all seat adjustments with

unit stationary, parking brake on and engine

shut off.

The seat is designed for one person. Do not

allow any passengers to ride on this machine.

To adjust seat forward or backward:

1. While seated, pull seat adjustment lever outward and

slide seat into desired position.

2. Release lever and slide seat forward or back to lock

seat into position.

To adjust the cushion spring for the weight of the operator:

1. Turn the knob clockwise for a heavier operator.

2. Turn the know counterclockwise for a lighter operator.

Hour Meter

Records total number of hours the engine has been in

operation.

IMPORTANT: Keep a record of Hour Meter readings for

recommended Lubrication and Maintenance intervals.

NOTE: For accurate readings be sure Ignition Switch is OFF

when unit is not in operation.

GB- 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 76 77

Comments to this Manuals

No comments

Ariens 991800-ProZoom 2352S Specifications Page 13

Comments to this Manuals

Related products and manuals for Lawnmowers Ariens 991800-ProZoom 2352S