Ariens 991800-ProZoom 2352S Specifications Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 77
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
4. Tightenthetwo3/8-16nutsontheu-bolttensionarm
untiltheextensionspringmeasures7.7"- 7.8"inside
hookto insidehook.
5. Lowerthefloorpan.
Relievetensionhere.p
i
Deck Drive Belt
Routing
Adjust Spring Tension I I
Length to 7.7" - 7.8"
Inside Hook to Inside Hook.
Figure 29
Pump Belt Removal and Installation
1. Make sure the mower is on a firm level surface, the
PTO switch is off, the engine is shut off, the steering
control levers are in the park position, the negative
battery cable is removed, and the lift control lever is
unlocked.
2. Place the deck in the highest position.
3. Release the deck belt tension by loosening the tension
spring. Remove the belt from the electric clutch. It is
not necessary to remove the deck belt from any other
pulleys.
IMPORTANT: Use care when releasing belt tension as the
pressure on the arm may cause injury or damage to the unit.
4. Release the tension from the pump belt by using a 3/8"
breaker bar in the square hole in the tension arm. Pull
back on the tension arm and pull the belt back behind
the engine pulley.
5. Slide the belt off the pump pulley. Slide the belt above
the pulley to allow the belts to be removed from the
other pulleys.
6. Once the belt is removed from the pump pulleys, it
should slide easily off the engine pulley and idler.
7. Install the new belt by sliding it above the pump
pulleys. Route the belt as shown in figure 30.
8. Pull back the idler, move the belt into position and then
slowly release the idler to tension the belt.
9. Reinstall the deck belt on the electric clutch pulley.
10. Properly retension the deck belt idler following
instructions in Drive Belt Removal and Installation on
page 28.
11. Connect the negative battery cable.
Belt Routing - Pumps
Figure 30
GB - 29
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 76 77

Comments to this Manuals

No comments