Ariens 991039 - Zoom 2452 HD Specifications download pdf (Page 19)

5.Spinnewoilfilterontofilterhousinguntil

itmakescontact.Tightenoilfilter

another3/4turn.

6.Installthefilterguardsremovedin

step2.Tightenthemountingscrewsto

65Ibf-in(7.3N°m).

7.Repeatsteps1-6fortheother

transaxle.

8.FollowtheinstructionsinTo Add

Hydraulic Fluid: on page 18.

3

1. Drain Plug

2. Oil Filter

3. Filter Guard

4. Mounting Hardware

Figure 8

4. Stop the engine and put the transaxle

bypass levers in the drive position. See

Moving the Unff with the Engine Off on

page 15.

5. Start the engine and slowly move the

steering levers in forward and reverse

five or six times.

6. Stop the engine, check the oil level and

add oil as needed.

7. Repeat steps 2-6 until the transaxles

operate smoothly in forward and reverse

at normal speeds without excessive

noise.

MOWER BLADES

Remove

_IL AUTION: Use sturdy gloves or

padding to protect hands when

working with mower blades.

1. Turn the engine off. Remove the ignition

key. Remove the ignition wire from the

spark plugs.

2. Remove the bolts, cup washer, and

blades from the spindle shafts.

Replace

1. Put the blades, cup washers, and the

bolts back on the spindle shafts.

2. Tighten the bolts to a torque of 115-

125 Ibf-ft (156-169.5 N°m).

3. Replace the ignition wire on the spark

plugs.

Purging the Hydraulic System

WARNING: This adjustment

requires operating the engine.

Use extreme care to avoid

contact with moving parts and hot

surfaces. Be sure rear of unit is

well supported and secure before

starting engine.

1. With the unit up to and facing a wall, jack

up the unit so that both drive wheels are

off the ground.

2. Disengage the parking brake and put the

transaxle bypass levers in the neutral

position. See Moving the Unff with the

Engine Off on page 15.

3. Start the engine and slowly move the

steering levers in forward and reverse

five or six times.

GB - 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 70 71

Comments to this Manuals

No comments