Ariens 935000 User Manual download pdf (Page 38)

DEALER ASSEMBLY & PRE-SERVICE

CLEVIS PIN

FRONT HANGER

BELT

TIGHTENER

HAIR PINS BRACKET

WASHERS

figure 31

With the Attachment Lift Lever in the third lowest

cutting notch, measure the distance from surface

to mower blades at the front and rear of the pan.

The rear of the blades should be Vs inch higher

than the front and the blades should hang even

side to side.

3. If adjustment is required, turn the hex nuts on the

rear hanger hooks to move the hooks up or down

to secure the proper adjustment. When the p?n is

leveled and hangs evenly, tighten the hex nuts.

See Figure 31.

4. Adjust mower belt for proper center distance. See

Figures 14 and 32. Adjust nuts on the adjustor

rod connected to the center of the front axle to

move mower pan forward or backward. Adjust 1

to 1 ’/2 inch clearance between belt as shown in

Figure 14 with mower pan in lowest and highest

positions.

CAUTION: ADJUSTMENT TOO FAR FORWARD WILL

NOT ALLOW MOWER BELT TO DECLUTCH! CHECK

FOR PROPER MOWER BELT DECLUTCHING IN ALL

HEIGHT POSITIONS. IF MOWER BELT DOES NOT

DECLUTCH, ADJUST MOWER PAN BACKWARD UN

TIL PROPER DECLUTCHING OCCURS. (PTO SHEAVE

MUST NOT HAVE A TENDENCY TO DRIVE MOWER

BELT AND/OR OVERRIDE BRAKE.) ADVISE

USER/OWNER OF THIS PROPER ADJUSTMENT AND

CHECK PROCEDURE.

ADJUSTMENT NUTS

MOUNTING POST

ON FRONT AXLE

ADJUSTOR ROD-

BELT TIGHTENER BRACKET

HAIR PIN

FIGURE 32

WARNING: THE CHUTE DEFLECTOR MUST BE AT

TACHED TO THE 32" MOWER PAN ON THE YT8

YARD TRACTOR BEFORE DELIVERY. THE TRACTOR

IS SHIPPED WITHOUT THE CHUTE DEFLECTOR IN

PLACE. ATTACH THE CHUTE DEFLECTOR (035243)

TO THE MOWER PAN CHUTE WITH THE TWO CAR

RIAGE BOLTS (6201 7) INSERTED FROM THE INSIDE,

AND SECURED WITH TWO LOCKNUTS (65040).

DEFLECTOR IS HELD DOWN BY THE CARRIAGE BOLT

(62042) AND WING NUT (65064) THROUGH THE

FLANGE ON THE FRONT OF THE DEFLECTOR AND

PAN. SEE "MOWER PAN CUTTING HEIGHT" SEC

TION, PAGE 9, ALSO.

ENGINE - FIGURE 28

Use high quality detergent type oil with service

designation SC, CC, SD, or SE. Oii weight specifica

tions are shown in "LUBRICATION" section of this

manual.

FILL FUEL TANK - FIGURE 28

Fill fuel tank with "regular" grade gasoline. Do not use

premium gasoline.

NOTE: THIS PRODUCT IS EQUIPPED WITH AN INTER

NAL COMBUSTION TYPE ENGINE. DO NOT USE UNIT

ON OR NEAR ANY UNIMPROVED, FOREST-COVERED

OR BRUSH-COVERED LAND UNLESS THE EXHAUST

SYSTEM IS EQUIPPED WITH A SPARK ARRESTER

MEETING APPLICABLE LOCAL, STATE OR FEDERAL

LAWS. A SPARK ARRESTER, IF IT IS USED, MUST BE

MAINTAINED IN EFFECTIVE WORKING ORDER BY

THE OPERATOR. SEE YOUR ARIENS DEALER OR

ENGINE MANUFACTURER'S SERVICE CENTER.

-38-

1 2 ... 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Ariens 935000 User Manual Page 38

Comments to this Manuals

Related products and manuals for Gardening equipment Ariens 935000