Ariens 936036 - 2548 Specifications Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
GB - 9
Throttle Lever
Move lever to fast (1) position to increase
engine speed. Move lever to slow (2)
position to decrease engine speed.
IMPORTANT:
Set throttle to approximately
1/2 speed when engaging PTO.
Choke
Apply choke when starting a cold engine.
To apply choke on model 936034:
Place throttle lever in choke position.
To apply choke on other models:
Pull choke knob out. Press knob in to
disengage choke.
Power Take-Off (PTO) Switch
The power take-off switch is used to engage
and disengage the attachment. Lift switch to
engage attachment. Push switch down to
disengage attachment.
Headlight Switch
With key in run position, ip light switch
forward (1) to turn headlights on. Flip light
switch backward (2) to turn headlights off.
Brake Pedal
Fully depress brake pedal to stop unit.
IMPORTANT: DO NOT leave foot on pedal
during operation as belt slippage may
occur.
Attachment Lift Lever
To raise attachment, depress thumb button
on lift lever and raise lever to raise
attachment.
To lower attachment, depress thumb button
and slowly allow lever to move downward to
lower attachment.
Parking Brake
To engage:
Fully depress brake pedal and pull parking
brake knob out.
To disengage:
Depress brake pedal.
Forward and Reverse Pedal
Press the front end of pedal downward to
move tractor forward.
Press the rear end of pedal downward to
move the tractor backward.
Removing foot from pedal returns unit to
neutral.
Seat Adjustment
1. Move the handle on the seat towards the center of
the tractor.
2. Slide seat into a comfortable position.
3. Release handle to lock seat in position.
Transmission Bypass Lever
Pull bypass lever rearward and lock in slot
to disengage transmission (2). Pull lever
out of slot and slowly release forward to
engage transmission (1).
IMPORTANT: Start unit with transmission
bypass lever in disengaged position when starting engine
in freezing temperatures (below 32˚F/0˚C). Slowly
engage transmission, allowing transmission to warm up
before applying load.
Cruise Control Switch
Use the cruise control switch to maintain
desired speed. Depress forward pedal to
desired speed and push the cruise control
switch forward to engage (1).
Flip cruise control switch back or depress
brake pedal to disengage (2) cruise control.
NOTE: Turning off cruise control switch
without foot on forward or reverse pedal will stop unit
abruptly.
IMPORTANT: If the forward pedal or reverse pedal is
repositioned while cruise indicator light is on, cruise will
reset at the new speed and/or direction selected.
Hood
To open, push hood latch to the right, lift hood and place
prop rod in slot under hood.
To close, remove prop rod from slot and lower it to side of
engine. Lower the hood until it rests on the latch. Press
down rmly at the center of the hood to snap it into latch.
Indicator Lights
The symbols on the dash will light up when key is turned
to the run position if one of the following conditions exist:
1
2
OT0710
1
2
OT0610
OT0650
OT0620
P
OT1580
1
2
OT0630
1
2
OT0640
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments